owners manual Skoda Yeti

all ratings: 0 average rating: 5

s2ug.6.book Page 208 Friday, April 9, 2010 2:24 PM 208 Inspecting and replenishing Inspecting the coolant level Caution One should contact a specialist garage as s oon as possible if the source of overheating itself cannot be determined and removed, since there may be grave damage to the engine. Replenishing the coolant – Switch the engine off. Fig. 165 Engine compartment: Coolant – Allow the engine to cool down. expansion bottle – Place a cloth over the cap of the coolant expansion reservoir  fig. 165 and The coolant expansion bottle is located in the engine compartment on the right.unscrew the cap carefully by turning it to the left . – Switch the engine off. –Top up the coolant. – Open the bonnet page203. – Screw the cap tight until it is heard to lock. – Check the level of coolant in the coolant expansion bottle  fig. 165. When the The coolant which you use for replenishing the system, must comply with one specific engine is cold, the coolant level must lie between the A a and A b markings. When specification page207. Do not use an alternative additive if the coolant additive the engine is warm, the level may also lie slightly above the hatched part.G13 is not available in exceptional cases. Just top up the system with water and as soon as possible arrange adjustment to correct the mixing ratio of water and coolant addi- If the coolant level in the reservoir is too low, this is indicated by the warning light in tive again by a specialist garage. the instrument cluster page33, “Coolant temperature/ Coolant quantity ”. We Only use fresh coolant for topping up the system. nevertheless recommend inspecting the coolant level directly at the reservoir from time to time. Do not top up the fluid above the hatched part! Excess coolant which is heated up is forced out of the cooling system through the pressure relief valve in the cap of the Loss of coolant coolant compensation bottle. A loss of coolant is first and foremost an indication of a leak in the system. You should Wait until the engine has cooled down for a system which has suffered a major loss of not merely top up the coolant in the reservoir. It is also important to have the cooling coolant before pouring in coolant. This is necessary to avoid engine damage. system inspected without delay by a specialist garage. Losses can only occur through the pressure relief in the cap of the coolant expansion WARNING bottle which is completely free of leaks if the coolant boils as a result of overheating  The cooling system is pressurized! Do not open the cap of the coolant and is forced out of the cooling system. expansion bottle if the engine is still hot - risk of scalding! WARNING  The coolant additive and thus all of the coolant is harmful to your health. Avoid contact with the coolant. Coolant vapours are also harmful to the health. Read and observe the warning notes page204, “Working in the engine It is important, therefore, to always safely store any coolant additive in its orig- compartment” before working in the engine compartment.inal container out of the reach of children - risk of poisoning!

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders