owners manual Subaru Forester

all ratings: 0 average rating: 5

Starting and operating 7-7 Starting the engine If the engine does not start, try the follow-NOTE ing. The engine may be difficult to start 1)Turn the ignition switch to the “OFF”when the battery has been disconnect- position and wait for at least 10 sec-ed and reconnected (for maintenance Do not operate the starter motoronds. After checking that the parkingor other purposes). This difficulty is continuously for more than ten sec-brake is firmly set, turn the ignitioncaused by the electronically controlled onds. If the engine fails to start afterswitch to the “START” position while de-throttle’s self-diagnosis function. To operating the starter for five to tenpressing the accelerator pedal slightlyovercome it, keep the ignition switch in seconds, wait for ten seconds or(about a quarter of the full stroke). Re-the “ON” position for approximately 10 more before trying again. lease the accelerator pedal as soon asseconds before starting the engine. the engine starts. Manual transmission vehicle 2)If this fails to start the engine, turn theAutomatic transmission vehi- ignition switch back to the “OFF” posi-cle 1. Apply the parking brake. tion and wait for at least 10 seconds. 2. Turn off unnecessary lights and acces-Then fully depress the accelerator ped-1. Apply the parking brake. sories. al and turn the ignition switch to the2. Turn off unnecessary lights and acces- 3. Press the clutch pedal to the floor and“START” position. If the engine starts,sories. shift the shift lever into neutral. Hold thequickly release the accelerator pedal.3. Shift the selector lever to the “P” or “N” clutch pedal to the floor while starting the3)If this fails to start the engine, turn theposition (preferably “P” position). engine. ignition switch again to the “OFF” posi-The starter motor will only operate when The starter motor will only operate whention. After waiting for 10 seconds orthe select lever is at the “P” or “N” position. the clutch pedal is pressed fully to thelonger, turn the ignition switch to the4. Turn the ignition switch to the “ON” po- floor. “START” position without depressingsition and check the operation of the warn- 4. Turn the ignition switch to the “ON” po-the accelerator pedal. ing and indicator lights. Refer to the sition and check the operation of the warn-4)If the engine still refuses to start, con-“Warning and indicator lights” section ing and indicator lights. Refer to thetact your nearest SUBARU dealer for(chapter 3). “Warning and indicator lights” sectionassistance. 5. Turn the ignition switch to the “START” (chapter 3). 6. Confirm that all warning and indicatorposition without depressing the accelera- 5. Turn the ignition switch to the “START”lights have gone off after the engine hastor pedal. Release the key immediately af- position without depressing the accelera-started. The fuel injection system auto-ter the engine has started. tor pedal. Release the key immediately af-matically lowers the idle speed as the en-If the engine does not start, try the follow- ter the engine has started. gine warms up. ing. – CONTINUED –

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders