owners manual Toyota Camry

all ratings: 0 average rating: 5


 ’05Camry_U (L/O 0409)  Programming a rolling code system The ceiling ountm ed garage door opener 6. Test the operation of the HomeLink by motor should now recognize the pressing the newly programmed button. If your device is “Rolling Code”  Check to see if the gate/device oper- HomeLink unit and be able activate the equipped, it is necessary to follow steps 1 through 4 under the heading garage door up/down. ates correctly.  “Programming the HomeLink” before 4. Repeat steps 1 through 3 for each re- 7. Repeat steps 1 through 6 for each re- proceeding with the steps listed below.   maining HomeLink button to program maining HomeLink button to program 1. Locate the “training” button on the ceil-another rolling code system. another device. ing mounted garage door opener motor.Programming an entrance gate/program-Programming other devices The exact location and color of thmieng all devices in the Canadian marketTo program other devices such as home button may vary by brand of garage  door opener. Refer to the owner’s 1. Decide which of the 3 HomeLink but-security systems, home door locks or guide supplied by the garage door tons you want to program. lighting, contact your authorized Toyota opener manufacturer for the location of 2. Place your hand-held gate/device dealer for assistance. transmitter 25 to 75 mm (1 to 3 in.) this “training” button. Reprogramming a button away from the surface of the  2. Press the “training” button on the ceil-  Individual HomeLink buttons cannot be ing mounted garage door opener motor.HomeLink . erased, however, to reprogram a single  Keep the indicator light on the HomeLinkbutton, follow the procedure “Programming Following this step, you have 30 seconds  in which to initiate step 3 below. in view while programming. the HomeLink ”.  3. Press and hold the se(b) Operatleingcte tdhe HomeLink 3. Press and release the vehicle’s pro-    HomeLink button. To operate the HomeLink, press the grammed HomeLink button twice. The  garage door may open. If the door 4. Continuously press and release (cycle)appropriate HomeLink button to activate  does open, the programming process isthe hand-held gate/device transmitter the programmed device. The HomeLink complete. If the door does not open, button every two seconds until step 5indicator light should come on. The  press and release the button a thirdis complete. HomeLink continues to send the signal for up to 20 seconds as long as the time. This third press and release will 5. When the indicator light on the button is pressed.  complete the programming process by HomeLink changes from a slow to a opening the garage door. rapid flash after 20 seconds, you can release both buttons. 205



 2005 CAMRY from Sep. ’04 Prod. (OM33684U)

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders