owners manual Hyundai Santa Fe

all ratings: 0 average rating: 5

WHAT TO DO IN AN EMERGENCY 3 8 D060D01A-AAT D060E01A-AAT D060F02E-AAT 3. Loosen Wheel Nuts 4. Put the Jack in Place 5. Raising the Car Wrench bar Wheel nut wrench HSM4018 D060E01O HFC4022 The wheel nuts should be loosenedThe base of the jack should be placed After inserting a wrench bar into the slightly before raising the car. To loosen on firm, level ground. The jack should wheel nut wrench, install the wrench bar the nuts, turn the wrench handle coun- be positioned as shown in the drawing. into the jack as shown in the drawing. terclockwise. When doing this, be sure To raise the vehicle, turn the wheel nut that the socket is seated completely wrench clockwise. As the jack begins over the nut so it cannot slip off. For to raise the vehicle, double check that maximum leverage, position the wrench it is properly positioned and will not slip. so the handle is to the left as shown in If the jack is on soft ground or sand, the drawing. Then, while holding the place a board, brick, flat stone or other wrench near the end of the handle, push object under the base of the jack to down on it with steady pressure. Do not keep it from sinking. remove the nuts at this time. Just loosen them about one-half turn. smhma-3.p65 8 7/28/04, 5:13 PM

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders