owners manual Seat Alhambra

all ratings: 0 average rating: 5

alhambra_aleman.book Seite 184 Montag, 23. M‰rz 2009 1:12 13 184 Intelligent technology WARNING (continued) The EDL will switch on again automatically when the brake has cooled down. • If the brake warning lamp  should light up together with the ABS WARNING warning lamp , stop the vehicle immediately and check the brake fluid level in the reservoir ⇒ page 223. If the fluid level has dropped below the Try to always adapt the speed of the vehicle to weather, road and traffic “MIN” mark you must not drive on. Risk of accident. You should obtain conditions. Do not let the extra safety afforded by the system tempt you professional assistance. into taking any risks when driving. Risk of accident. • If the brake fluid level is correct, the fault in the brake system may have • When accelerating on a slippery surface, for example on ice and snow, been caused by a failure of the ABS control function. This could cause the press the accelerator carefully. Despite EDL, the driven wheels may other- rear wheels to lock quickly when you brake. This could cause the tail of the wise start to spin. This could impair the car's stability. vehicle to skid sideways. Drive carefully to the nearest qualified workshop • Always adapt your driving style to suit road conditions and the traffic and have the fault corrected. situation. Electronic differential lock (EDL) WARNING Modifications to the vehicle or work carried out incorrectly (e.g. to the The electronic differential lock helps prevent the loss of trac-engine, the brake system, running gear or any components affecting the tion caused if one of the driven wheels starts spinning.wheels and tyres) could affect the efficiency of the ABS, EDL, ESP and TCS and lessen their efficiency. The electronic differential lock (EDL) only works when the engine is running. EDL helps the vehicle to start moving, accelerate and climb a gradient in slip- pery conditions where this may otherwise be difficult or even impossible.Electronic stabilisation programme (ESP) It uses the ABS sensors to monitor the speed of the driven wheels.The electronic stabilisation programme helps to reduce the At speeds of up to approximately 80 km/h, it is able to balance out differ-danger of skidding. ences in the speed of the driven wheels of approximately 100 rpm caused by a slippery road surface on one side of the vehicle. It does this by braking the The electronic stabilisation programme (ESP) consists of ABS, EDL and TCS wheel which has lost traction and distributing more driving force to the other and only works when the engine is running. driven wheel via the differential. To prevent the disc brake of the braked wheel from overheating, the EDL cuts The ESP should generally be left switched on at all times. Only when the out automatically if subjected to excessive loads. The car remains operational necessary drive can not be obtained should the ESP be disconnected. and will behave in the same way as a car without EDL. For this reason, the For example: driver is not informed that the EDL has been switched off.• when driving with snow chains,

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders