Audi A4 B8 owners manual page 183

text version of content this owner's manual page from owners manual to the vehicle Audi A4, year of production 2008 - 2015:

document_0900452a81b1b9de.book Seite 181 Donnerstag, 26. Juli 2007 9:16 09 HomeLink 181 Activating the garage door opener drive unit Applies to vehicles: with HomeLink – Locate the programming button on the garage door Operating HomeLink drive. The exact location and colour of the button may The programmed devices are activated by means of the vary depending on the type of garage door opener. HomeLink control buttons in the headliner. – Press the programming button on the door drive unit – Make sure that the ignition is on. (this will normally cause a “programming mode indicator – Press the programmed HomeLink button ⇒ page 179, lamp” on the unit to light up). You now have about 30 seconds to start and complete the programming of the fig. 197. The device assigned to that button (e.g. garage HomeLink control button on the operating unit. door) will be activated. Programming at the operating unit in the The HomeLink indicator diode ⇒ page 179, fig. 197 will light up headliner when you press the button. – Press and release the already programmed HomeLink button. Applies to vehicles: with HomeLink Erasing the button programming – Press the HomeLink button again to complete rolling You can erase the complete HomeLink programming by code programming. pressing the two outer buttons. After programming at the operating unit in the headliner, the – Switch on the ignition (do not start the engine). garage door opener should recognize the HomeLink signal and respond when the HomeLink button is pressed. Now the other – Press and hold down the two outer buttons until the indi- control buttons can be programmed as required. cator diode starts to flash ⇒ page 179, fig. 197. Note – Then release the buttons. • Having a second person assist you makes programming of the After the programming of the HomeLink buttons has been erased, rolling code easier and faster. For some makes of garage door the system will return to the training mode and is ready to be re- openers the HomeLink button may have to be pressed a third time programmed at any time. to complete the training sequence. • If you encounter problems programming the rolling code you Note may find helpful information in the operating instructions of the • Programmed buttons cannot be erased individually. garage door opener or other device you wish to operate. • For security reasons it is advisable to erase the programming of the HomeLink buttons prior to selling your vehicle. Controls Safety Driving tips General maintenance Self-help Technical data

owners manual Audi A4

owners manual Audi A4 - year of production: 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 - Audi A4 B8 owners manual EN