owners manual Seat Ibiza

all ratings: 0 average rating: 5

176 Driving and the environment Avoid short journeys Note To reduce the consumption and emission of polluting exhaust gases, the ● If you vehicle has Start-Stop, it is not recommended to switch this func- engine and the exhaust gas filtration systems should reach the optimum tion off. operating temperature. ● It is recommended to close the windows when driving at more than With the engine cold, fuel consumption is proportionally higher. The engine 60 km/h (40 mph) does not warm up and fuel consumption does not normalise until having ● Do not drive with your foot resting on the clutch pedal, as the pressure driven approximately four kilometres (2.5 miles). This is why we recommend can make the plate spin, more fuel will be used and it can burn the clutch avoiding short trips whenever possible. plate lining, causing a serious fault. Maintain the correct tyre pressures ● Do not hold the vehicle on a hill with the clutch, use the foot brake or hand brake, using the latter to start. The fuel consumption will be lower and Bear in mind that keeping the tyres at an adequate pressure saves fuel. If you will prevent the clutch plate from being damaged. the tyre pressure is just one bar too low, fuel consumption can increase by ● On descents, use the engine brake, changing to the gear that is more as much as 5%. Due to the greater rolling resistance, under-inflation also suitable for the slope. The fuel consumption will be lower and the brakes increases tyre wear and impairs handling.  will not suffer. The tyre pressures should always be checked when the tyres are cold. Do not use winter tyres all year round as they increase fuel consumption by up to 10%. Environmental friendliness Avoid unnecessary weight Environmental protection is a top priority in the design, choice of materials Given that every kilo of extra weight will increase the fuel consumption, it is and manufacture of your new SEAT. advisable to always check the luggage compartment to make sure that no unnecessary loads are being transported. Constructive measures to encourage recycling ● Joints and connections designed for easy dismantling A roof rack is often left in place for the sake of convenience, even when it is no longer needed. At a speed of 100-120 km/h (60-75 mph) your vehicle● Modular construction to facilitate dismantling will use about 12% more fuel as a result of the extra wind resistance caused ● Increased use of single-grade materials by the roof rack even when it is not in use. ● Plastic parts and elastomers are marked in accordance with ISO 1043, ISO 11469 and ISO 1629 Save electricity The engine activates the alternator, which produces electricity. With the Choice of materials need for electricity, fuel consumption is also increased. Because of this, al- ● Use of recycled materials. ways turn off electrical components when you do not need them. Examples ● Use of compatible plastics in the same part if its components are not of components that use a lot of electricity are: the fan at high speeds, the easily separated.  rear window heating or the seat heaters*.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders