owners manual Skoda Superb

all ratings: 0 average rating: 5

Intelligent Technology173 fied. Drive at a reduced speed while on your way to the dealer and adapt Antiblock brake system (ABS) your style of driving to the higher brake pedal pressure required. Low brake fluid level ABS prevents the wheels locking when braking. An insufficient level of brake fluid may result in problems in the brake General system. The level of the brake fluid is monitored electronically ⇒ page 35.The ABS contributes significantly to enhancing the active safety of your vehicle. Compared to a car not fitted with the ABS brake system, you are WARNING able to retain optimal steering ability even during a full brake application • Only apply the brakes for the purpose of drying and cleaning on a slippery road surface because the wheels do not lock up. the brake discs if the traffic conditions permit this. Do not place You must not expect, however, that the braking distance will be shorter any other road users in jeopardy. under all circumstances as a result of the ABS The braking distance for • When retrospectively mounting a front spoiler, solid wheel example on gravel and fresh snow, when you should anyway be driving slowly and cautiously, will be longer. hubs etc. one must ensure that the air supply to the front wheel brakes is not reduced otherwise the braking system could run too Operating principle hot. As soon as the vehicle speed has increased to about 6 km/hour an auto- • Allow for the fact that new brake pads do not achieve their full matic test procedure is conducted during which you will be able to hear a braking efficiency until approximately 200 kilometres. New brake pumping noise for about 1 second. pads must be first “run in” before they develop their optimal fric-The brake pressure will be reduced on a wheel which is rotating at a speed tion force. You can, however, compensate for this slightly reduced which is too low for the speed of the vehicle and tending to lock. This braking force by increasing the pressure on the brake pedal. This control cycle is noticeable from a pulsating movement of the brake guideline also applies to any new brake pads installed at a future pedal which is accompanied by noises. This is consciously intended to date. provide the driver with the information that the wheels are tending to lock (ABS control range). You must always keep the brake pedal depressed to Caution enable the ABS to optimally control the brake application in this braking • Never allow the brakes to rub by applying slight pressure if you do not range. Never interrupt the application of the brakes! wish to brake the vehicle. This causes the brakes to overheat and can also result in a longer braking distance and excessive wear. • Before negotiating a steep downhill section, please reduce your speed, shift down into the next lower gear (manual gearbox) or select a lower driving stage (automatic gearbox). This enables you to make full use of the braking power of the vehicle and reduces the strain on the brakes. Any additional braking should be done intermittently, not continuously. Using the systemSafety Driving Tips General MaintenanceBreakdown assistanceTechnical Data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders