owners manual Skoda Rapid

all ratings: 0 average rating: 5

C 0he jump-start cable must be connected to the engine earthing point 3ARNING (Continued) » Fig. ĖĜė only on vehicles with the S0AR0-S0OP system. ■ 0he jump-start cable connected to the positive terminal of the battery must not come into contact with electrically conducting parts of the vehicle Starting engine – there is a risk of short circuit! ›Start the engine on the vehicle providing the power and allow it to idle. ■ Route the jump-start cables so that they cannot be caught by any rotat- ›Start the engine of the vehicle with the discharged battery. ing parts in the engine compartment. ›If the engine does not start, halt the attempt to start the engine after Ėĕ sec- onds and wait for Ęĕ seconds before repeating the process. ›Remove the jump start cables in the reverse order as attachment. 0owing the vehicle Engines in vehicles with the vehicle battery in the boot 0he positive terminal A is located under a cover in the engine compartmentIntroduction » Fig. ĖĜĘ. ›1nlock the retainer tab on the cover in direction of arrow Ė . ›Open the cover in the direction of the arrow ė . ›Clamp the positive terminal of the jumper cable to the position A » Fig. ĖĜĘ. ›Clamp the negative terminal of the jumper cable to the earthing point of the engine D » Fig. ĖĜė or to a metal part firmly connected to the engine block or directly to the engine block. ›Remove the jump start cables in the reverse order as attachment. Both batteries must have a rated voltage of Ėė 2. 0he capacity (Ah) of the bat- tery supplying the power must not be significantly less than the capacity of Fig. ĖĜę Braided tow rope / Spiral tow rope the discharged battery in your vehicle. Jump-start cables 0his chapter contains information on the following subjects: Only use jump-start cables which have an adequately large cross-section and Front towing eye ĖĜĕ insulated terminal clamps. Observe the instructions of the jumper lead manu- Rear towing eye ĖĜĖ facturer. 2ehicles with a tow hitch ĖĜĖ Positive cable – colour coding in the majority of cases is red. For towing a braided tow rope is to be used » Fig. ĖĜę- . Negative cable – colour coding in the majority of cases is black. 3hen towing, the following guidelines must be observed. 3ARNING 2ehicles with manual transmission may be towed in with a tow bar or a tow ■ Do not clamp the jump-start cable to the negative terminal of the dis- rope or with the front or rear wheels raised. charged battery. 0here is the risk of detonating gas seeping out of the bat- 2ehicles with automatic transmission may be towed in with a tow bar or a tow tery being ignited by the strong spark resulting from the engine being star- rope or with the front wheels raised. If the vehicle is raised at the rear, the au- ted. tomatic gearbox will be damaged! If possible, the vehicle should be towed with ■ 0he non-insulated parts of the terminal clamps must never touch each the engine running or at least with the ignition on. other – there is a risk of short circuit! Driver of the tow vehicle ›Engage the clutch gently when starting off or depress the accelerator partic-  ularly gently if the vehicle is fitted with an automatic gearbox. Emergency equipment and self-helpĖěĞ

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders