owners manual Seat Toledo

all ratings: 0 average rating: 5

Advice ●Replace the cover again or close the fuseThe light source used for each function is lis- For the sake of the environment box lid. ted below: Please ask your specialist retailer how to dis- pose of used bulbs in the proper manner. CAUTION Double headlights If you replace a fuse with higher-rating fuse,Dipped beam: H7 Long Life Note you could cause damage to another part of Main beam: H7 the electrical system. ● Depending on weather conditions (cold or Side lights: W5W Long Life wet), the front lights, the fog lights, the rear lights and the turn signals may be temporari- Turn signals: PY21W NA ly misted. This has no influence on the useful Daytime driving lights: P21W Super Long Life Changing bulbs life of the lighting system. By switching on the lights, the area through which the beam WARNING of light is projected will quickly be demisted. Introduction ● However, the edges may continue to be mis- Take particular care when working on com- ted. ponents in the engine compartment if the en- Changing bulbs requires a certain degree of gine is warm. Risk of burns. ● Please check at regular intervals that all practical skill. If in doubt, we recommend you ● lighting (especially the exterior lighting) on have defective bulbs changed by a special-Bulbs are highly sensitive to pressure. The your vehicle is functioning properly. This is glass can break when you touch the bulb, ised service or, in case of an emergency, not only in the interest of your own safety, causing injury. seek professional assistance. but also that of all other road users. ● The high voltage element of gas discharge ●Switch off the ignition and all of the lights ● Before changing a bulb, make sure you bulbs* (xenon light) must be handled correct- before changing a bulb. have the correct new bulb. ly. Otherwise, there is a risk of death. ● ● Do not touch the glass part of the bulb with Do not touch the glass part of the bulb with● When changing bulbs, please take care not your bare hands, use a cloth or paper towel your bare hands. The fingerprints left on theto injure yourself on sharp parts in the head- instead. Otherwise, the fingerprints left on glass will vaporise as a result of the heat gen-light housing. the glass will vaporise as a result of the heat erated by the bulb, reducing bulb life and generated by the bulb, they will be deposited causing condensation on the reflector sur- CAUTION on the reflector and damage its surface. face, thus reducing effectiveness. ● Remove the ignition key before working on ●A bulb must only be replaced by one of the the electric system. Otherwise, a short circuit same type. The type is indicated on the bulb, could occur. either on the glass part or on the base. ● Switch off the lights and the parking light ●There is a storage area for the bulb box in before changing a bulb. the spare wheel well or below the carpet in the luggage compartment. 166

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders