owners manual Nissan Murano

all ratings: 0 average rating: 5

system as soon as possible. (MIL)” in the “2. Instrument and controls” Accelerator downshift section. This will occur even if all electrical —In D position — circuits are functioning properly. In this case,turntheignitionkeyOFFandwaitfor For rapid passing or hill climbing, fully depress3 seconds. Then turn the key back to the the accelerator pedal to the floor. This shifts theONposition.Thevehicle should return to transmission down into lower range, dependingits normal operating condition. If it does on the vehicle speed. not return to its normal operating condi- tion, have your NISSAN dealer check the High fluid temperature protection transmission and repair if necessary. mode WARNING This transmission has a high fluid temperature protection mode. If the fluid temperature be-Whenthehighfluidtemperatureprotec- SSD0290 comes too high (for example, when climbingtion mode or fail-safe operation occurs, Shift lock release steep grades in high temperature with heavy loads, such as when towing a trailer), enginevehicle speed may be gradually re- If the battery charge is low or discharged, thepower and, under some conditions, vehicleduced. On highways, the reduced speed selector lever may not be moved from the Pspeedwill be decreased automatically to reducemay be lower than other traffic which (Park) position even with the brake pedal de-the chance of transmission damage. Vehiclecould increase the chance of a collision. pressed. speed can be controlled with the acceleratorBe especially careful when driving. If pedal, but the vehicle may not accelerate abovenecessary, pull to the side of the road at To move the selector lever, depress the brakeapproximately 40 to 50 MPH (65 to 80 km/h).a safe place and allow the transmission pedal, removethecoverusingasuitabletoolandFail-safe to return to normal operation, or have it push the shift lock release button. The selector repaired if necessary. lever can be moved to N (Neutral). This allowsIf the vehicle is driven under extreme con- the vehicle to be moved if the battery is dis-ditions, such as excessive wheel spinning charged. andsubsequenthardbraking, the fail-safe If the selector lever cannot be moved out of Psystem may be activated. The MIL may come on to indicate the fail-safe mode is (Park), have your NISSAN dealer check the CVTactivated, see “Malfunction indicator lamp Starting and driving 5-13
03.1.28/Z50-D/V5.0 

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders