owners manual Nissan Murano

all ratings: 0 average rating: 5

STARTING THE ENGINE DRIVING THE VEHICLE 1. Apply the parking brake. CVT (Continuously Variable 2. Move the selector lever to P (Park) or NCAUTIONTransmission) (Neutral). (P preferred.) Gate type shift The starter is designed not to operate if theDonotoperatethestarterformorethan selector lever is in one of the driving posi-15 seconds at a time. If the engine doesThe CVT in your vehicle is electronically con- tions. not start, turn the key off and wait 10trolled by a transmission control module to pro- seconds before cranking again, other-duce maximum power and smooth operation. 3. Crank the engine with your foot off thewise the starter could be damaged.Shown on the following pages are the recom- accelerator pedal by turning the ignition mended operating procedures for this transmis- key to START. Release the key when the4. Warm-upsion. Follow these procedures for maximum ve- engine starts. If the engine starts, but fails tohicle performance and driving enjoyment. run, repeat the above procedure.Allow the engine to idle for at least 30
When the engine is very hard to start inseconds after starting. Drive at moderateStarting the vehicle extremely cold weather or when restarting,speed for a short distance first, especially in depress the accelerator pedal a little (ap-cold weather.After starting the engine, fully depress the foot proximately 1/5 to the floor) and hold it then brake pedal before shifting the selector lever to crank the engine. Release the key and the the R (Reverse), N (Neutral), D (Drive), S (Sec- accelerator pedal when the engine starts. ond) or L (Low) position. Be sure the vehicle is fully stopped before attempting to shift the se-
When the engine is very hard to start be- lector lever. cause it is flooded, depress the accelerator This CVT model is designed so that the pedal all the way to the floor and hold it. foot brake pedal must be depressed be- Crank the engine for 5 to 6 seconds. After fore shifting from P (Park) to any drive cranking the engine, release the accelerator position while the ignition switch is ON. pedal. Crank the engine with your foot off The selector lever cannot be moved out of the accelerator pedal by turning the igni- P(Park) position and into any of the other tion key to START. Release the key when the shift range if the ignition key is turned to engine starts. If the engine starts, but fails tothe LOCK, OFF or ACC position or if the run, repeat the above procedure. key is removed from the switch. 5-10 Starting and driving
03.1.28/Z50-D/V5.0 

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders