owners manual Fiat Tipo

all ratings: 0 average rating: 5

ENGINEOIL ENGINECOOLANTFLUID IMPORTANTBrakefluid is hygroscopic 151) 152) (i.e. it absorbs moisture). For this reason, if the vehicle is mainly used in CARE 56) 58) areas with a high degree of Check the oil level a few minutes (about If the level is too low, unscrew the cap atmospheric humidity, the fluid should AND 5) after the engine has stopped, with of reservoir 4 and add the fluid be replaced at more frequent intervals the vehicle parked on level ground. described in the "Technical than specified in the "Scheduled Check that the oil level is between the Specifications" chapter. Servicing Plan". MINandMAXreferencesonthe WINDSCREEN/REAR BATTERY dipstick. WINDOWWASHINGFLUID VICINGIf the level of the oil is close to or below 157) 158) 159) the MIN mark, add oil via the filler fitting 153) 154) 59) SER until the MAX mark is reached. If the level is too low, raise the reservoir Take out the engine oil dipstick, clean it 4) with a lint-free cloth and reinsert it. cap 3 and add the fluid described in the The battery does not require the Extract it again and check that the level "Technical Specifications" chapter. electrolyte to be topped up with distilled is between the MIN and MAX marks on BRAKEFLUID water. the dipstick. 155) 156) Aperiodic check carried out at a Fiat Engine oil consumption Dealership is, however, necessary to 59) check efficiency. 57) Check that the fluid is at the max. level. Replacing the battery 3) If the fluid level in the reservoir is too If necessary, replace the battery with The maximumengine oil consumption low, undo the reservoir cap 1 and add another original battery with the same is usually 400 grams every 1000 km. the fluid described in the "Technical specifications. Follow the battery Whenthecarisnew,theengine needs Specifications" chapter. Manufacturer’s instructions for to be run in; therefore the engine oil IMPORTANTCarefully clean the cap of maintenance. consumption can only be considered the reservoir and the surrounding stabilised after the first 5000 - 6000 km. surface. Take great care to ensure that IMPORTANTAfter adding or changing impurities do not enter the reservoir the oil, let the engine turn over for a few whenthecapisopened. seconds and wait a few minutes after For topping-up, always use a funnel turning it off before you check the level. with integrated filter with mesh equal to or lower than 0.12 mm. 156

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders