Audi A5 owners manual page 157

text version of content this owner's manual page from owners manual to the vehicle Audi A5, year of production 2007:

document_0900452a8179700c.book Seite 155 Donnerstag, 22. März 2007 10:19 10 HomeLink 155 At the operating unit The proper distance between the hand-held transmitter and the 1. Switch on the ignition (do not start the engine). HomeLink module at the radiator grille depends on the system you want to train. It may require several attempts. 2. Press and hold down the two outer HomeLink buttons The turn signals will flash once if the time limit for the programming ⇒page154, fig. 171 until the indicator diode A A mode has been exceeded. In this case the programming procedure ⇒page154, fig. 171 begins to flash after about needs to be performed again. Repeat the sequence at the operating 20seconds. This procedure will delete the standard unit starting with step 3. factory settings and does not need to be repeated when The programming instructions above also apply to the other control programming the other buttons. buttons. Start with step 3 if you wish to proceed and program the 3. Press the particular HomeLink button which you would other two buttons. like to program. If the garage door or other devices st ill fail to be activated with the HomeLink control buttons after programming is completed, it is 4. Wait until the diode A begins to flash. The HomeLink A possible that these systems might be working with a rolling code module now remains in training mode for 5 minutes. instead of the normal fixed security code. If this is the case, a rolling 5. Now step in front of your vehicle with the original hand- code programming is required in addition to the steps described held transmitter for the garage door opener or any other above. ⇒ page 155 device you wish to assign to the HomeLink control button. Applies to vehicles: with HomeLink Rolling code programming At the radiator grille Some devices require rolling code programming of the 6. Hold the original hand-held transmitter at or near the HomeLink universal transmitter. centre of your car's radiator grille ⇒ page 154, fig. 172. 7. Press the activator button on the original hand-held Identifying a rolling code transmitter. – Press the already programmed HomeLink button again and hold it down. 8. As you do so, watch the turn signals on your vehicle. A –Watch HomeLink diode ⇒ page154, fig. 171. If the HomeLink confirms successful programming by flashing A all four turn signals three times. diode starts flashing rapidly and turns into a constant light after about 2 seconds, this indicates that the device 9. If the turn signals fail to flash three times, repeat the you wish to operate (e.g. a garage door opener) is procedure with the transmitter held at a different equipped with a rolling code. distance from the radiator grille. – Program the rolling code as follows: Controls Safety Driving tips General maintenance Self-help Technical data

owners manual Audi A5

owners manual Audi A5 - year of production: 2007 - Audi A5 owners manual EN