owners manual Nissan Murano

all ratings: 0 average rating: 5

Black plate (153,1) surface. Hold the transmitter in that position3. Push and hold the hand-held transmitter may not cause harmful interference, and for up to 15 seconds. If HomeLink® is not button. (2) this device must accept any interfer- programmed within that time, try holding the 4. The HomeLink® indicator light will flash, firstence received, including interference that transmitter in another position - keeping the slowly and then rapidly. When the indicator may cause undesired operation. indicator light in view at all times. light begins to flash rapidly, release both Note: Changes or modifications not ex- If you continue to have programming difficulties, buttons. pressly approved by the party responsible please contact the NISSAN Consumer Affairs The HomeLink® Universal Transceiver button for compliance could void the user’s Department. The phone numbers are located in has now been reprogrammed. The new device authority to operate the equipment. the Foreword of this Owner’s Manual. can be activated by pushing the HomeLink® For Canada: CLEARINGTHE PROGRAMMED IN- button that was just programmed. This proce- This device complies with RSS-210 of FORMATION dure will not affect any other programmed Industry Canada. Operation is subject to GUID-8C1871E3-C252-465F-A399-47B1EB58E018HomeLink® buttons. Individual buttons cannot be cleared, however to the following two conditions: (1) this clear all programming, push and hold the two IF YOUR VEHICLE IS STOLEN device may not cause interference, and outside buttons and release when the indicator GUID-464C8E7D-4693-445C-BEED-4B9B07479827(2) this device must accept any interfer- If your vehicle is stolen, you should change the light begins to flash (in approximately 20 ence, including interference that may codes of any non-rolling code device that has seconds). been programmed into HomeLink®. Consult the cause undesired operation of the device. REPROGRAMMINGASINGLE Owner’s Manual of each device or call the HomeLink® BUTTON manufacturer or dealer of those devices for GUID-2BF52974-A0FA-4080-821F-2E188B5DC58B To reprogram a HomeLink® Universal Transcei- additional information. ver button, complete the following. When your vehicle is recovered, you will ® need to reprogram the HomeLink® Univer- 1. Push and hold the desired HomeLink button. Do not release the button until step sal Transceiver with your new transmitter 4 has been completed. information. 2. When the indicator light begins to flash FCC Notice: slowly (after 20 seconds), position the For USA: hand-held transmitter 2 to 5 in (50 to 127 This device complies with Part 15 of the mm) away from the HomeLink® surface. FCC Rules. Operation is subject to the following two conditions: (1) This device Instruments and controls 2-65 [ Edit: 2011/ 7/ 18Model: Z51-D ]

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders