Nissan Murano Z51 owners manual page 152

text version of content this owner's manual page from owners manual to the vehicle Nissan Murano, year of production 2008:

Black plate (152,1) button - releasing when the device begins to HomeLink® button you’ve just programmed. NOTE: activate. Push and release the HomeLink® button up If programmingagaragedooropener,etc., 5. Ifthe indicator light on HomeLink® blinks to three times to complete the training. it is advised to unplug the device during rapidly for two seconds and then turns solid, ® the “cycling” process to prevent possible 8. Your HomeLink button should now be HomeLink® has picked up a “rolling code” programmed. To program the remaining damage to the garage door opener com- garage door opener signal. You will need to HomeLink® buttons for additional door or ponents. proceed with the next steps to train gateopeners, follow steps 2 through 8 only. OPERATINGTHE HomeLink® UNIVER- ® HomeLink , completing the programming NOTE: SALTRANSCEIVER may require a ladder and another person GUID-19BE850B-BBDC-470B-9850-DE6B57FF6B98 ® for convenience. Do not repeat step 1 unless you want to HomeLink Universal Transceiver (once pro- grammed) may now be used to activate the “clear” all previously programmed 6. Push and release the program button ® garage door, etc. To operate, simply push the HomeLink buttons. ® located on the garage door opener’s motor If you have any questions or are having difficultyappropriate programmed HomeLink Universal to activate the “training mode”. This button isprogramming your HomeLink® buttons, please Transceiver button. The red indicator light will usually located near the antenna wire that ® illuminate while the signal is being transmitted. hangs down from the motor. If the wire refer to the HomeLink web site at: www. originates from under a light lens, you will homelink.com or call 1-800-355-3515. PROGRAMMINGTROUBLE-DIAGNO- ® SIS need to remove the lens to access the PROGRAMMINGHomeLink FOR CA- GUID-0B904713-E37A-46A3-9A90-63FADE14E79C training button. NADIAN CUSTOMERS If HomeLink® does not quickly learn the hand- GUID-8263D00C-5505-4CBD-9B5E-CB372155C17Aheld transmitter information: NOTE: Prior to 1992, D.O.C. regulations required Once you have pushed and released hand-held transmitters to stop transmitting after. replace the hand-held transmitter batteries the training button on the garage door 2 seconds. To program your hand-held trans- with new batteries. mitter to HomeLink® . position the hand-held transmitter with its opener’s motor and the “training light” , continue to push and hold is lit, you have 30 seconds in which to the HomeLink® button (note steps 2 through 4 battery area facing away from the ® HomeLink® surface. perform step 7. For convenience, use under “Programming HomeLink ”) while you the help of a second person to assist push and re-push (“cycle”) your hand-held . push and hold both the HomeLink® and when performing this step. transmitter every 2 seconds until the indicator hand-held transmitter buttons without inter- 7. Quickly (within 30 seconds of pushing and light flashes rapidly (indicating successful pro- ruption. releasing the garage door opener training gramming). . position the hand-held transmitter 2 to 5 in button) and firmly push and release the (50 to 127 mm) away from the HomeLink® 2-64 Instruments and controls [ Edit: 2011/ 7/ 18Model: Z51-D ]

owners manual Nissan Murano

owners manual Nissan Murano - year of production: 2008 - Nissan Murano Z51 owners manual EN