owners manual Seat Toledo

all ratings: 0 average rating: 5

Advice Vehicle tool kit* Before stowing the jack again, screw down ● If you have a flat tyre, stop the vehicle as the arm as far as it will go. far away as possible from moving traffic. Stop on flat, solid ground. WARNING ● If you have to change the tyre on a gradi- ● The factory-supplied jack is only designedent, block the wheel opposite the wheel be- for changing wheels on this model of vehicle.ing changed by placing a stone or similar ob- On no account attempt to use it for lightingject under it to prevent the vehicle from roll- heavier vehicles or other loads. Risk of injury!ing away unexpectedly. ● ● If the vehicle has been fitted with tyres or Make sure that the vehicle tools are stored properly in the luggage compartment.alloys that are different to those fitted in manufacture, the instructions ››› page 146, Replacing tyres and wheels must be followed. Note ● Always raise the vehicle with the doors ● Make sure the box always remains strap- closed. Fig. 122 Vehicle tool kit. ped to the spare wheel with tape. ● Never place parts of your body, e.g. arms ● The jack does not generally require any The vehicle tool kit and the jack are stored in and legs, underneath the vehicle when it is maintenance. If required, it should be a box on the spare wheel or in the spare supported only by the jack. greased using universal type grease. wheel well. There is also enough space for ● Secure the base of the jack with suitable the towing bracket ball coupling. The box is supports so that it cannot slip. The jack could strapped to the spare wheel with tape. slide if the ground below it is soft and slip- pery and the vehicle could slip off it. There- Changing a wheel The vehicle tool kit includes the following fore, place the jack on a firm surface or use a parts (depending on equipment): large, stable base. On a slippery surface, e.g. Introduction tile, use a non-slip base such as a rubber 1 Screwdriver mat. 2 Adapter for anti-theft wheel bolts WARNING ● Never start the engine when the vehicle is 3 Towline anchorage jacked. Risk of injury. ● If you have a puncture in moving traffic, 4 Wire hook for removing hub caps ● The jack should only be used in the correct switch on the hazard warning lights and place the warning triangle at the obligatoryjacking points. 5 Jack distance. Observe applicable local legal regu- 6 Box spanner for wheel bolts lations. This is for your own safety and that of CAUTION 7 Clip for wheel bolt cover other drivers. ● The prescribed tightening torque for wheel 8 Spare set of bulbs bolts on steel and alloy wheels is 120 Nm. 150

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders