instrukcja obsługi Suzuki SX4 S Cross Suzuki SX4 S Cross owners manual page 150

text version of content this owner's manual page from owners manual to the vehicle Suzuki SX4 S-Cross, year of production 2013:

OPERATING YOUR VEHICLE problem with the system, the starter engine restarted. This is not a malfunc- NOTICE motor will rotate only while the engine tion. In this case, always let the engine • Do not depress the accelerator dur-switch is being pressed. idle before stop it. ing the engine starting procedure. • If the engine does not respond Stopping the engine Starting a Cold and Warm Engine you try to start it with the when • Depress the engine switch to stop the (For Gasoline Engine Model) engine switch or if the engine engine after the vehicle stopped com-With your foot off the accelerator pedal, switch repeats cycling through the pletely. crank the engine by pressing the engine "OFF" - "ACC" - "ON" mode, the • In case of emergency, you can stop the switch to change the ignition mode to vehicle battery may be discharged. engine by quickly pushing the engine "START'. Check the voltage of the vehicle switch more than 3 times, or pushing battery before trying again. and holding the engine switch more than NOTICE NOTE: 2 seconds while the vehicle in motion. Do not crank the engine for more You do not need to keep the engine NOTE: than 12 seconds at a time. switch pressed If the engine doesn't start on the first to start the engine. Except in emergency, do not stop the try, wait about 15 seconds before try- The engine of a manual transaxle vehi-engine while the vehicle in motion. ing again. cle will not start unless the clutch pedal The steering and braking operation will is depressed. require more efforts when the engine CVT vehicles have a starter interlock stopped. After pressing the engine switch to change device which is designed to keep the Refer the ignition mode to "START', the starter starter from operating to "Braking" in this section. if the transaxle is cranks the engine for about 12 seconds in any of the drive positions. NOTICE before it can start the engine. If the engine During the engine starting procedure, If you stop the engine while the vehi-fails to start at the first attempt, wait about messages on the information display will motion, the CVT may be dam-15 seconds, then try again while keeping help you. Refer cle is in to "Information Display" aged. the engine switch pressed while preSSing in the "BEFORE DRIVING" section for Avoid down the accelerator pedal to 1/3 of its details. stopping the engine while driv-travel. Release the accelerator pedal when You should turn off such loads as the ing. the engine starts. headlights and air conditioning system to If the engine still does not start, try holding facilitate starting of the engine. • If the engine has been stopped and the accelerator pedal all the way to the Even if you fail to start the engine, the stayed as it as for while after the engine floor while cranking. This should clear the starter motor will stop turning automati-was stopped unexpectedly or was raced engine if it is flooded. cally after a short time. After the starter before stopped, a clicking sound may be motor has stopped or if there is some heard from around the engine when 3-15