owners manual Seat Cordoba

all ratings: 0 average rating: 5

COR_ING_0707 Seite 137 Mittwoch, 1. August 2007 6:25 18 Driving 137 If, while driving, the selector lever accidentally moves to position N, first • The gearbox does not automatically engage gears. release the accelerator pedal and wait un til the engine slows to idling before In this case they can be changed manually. 3rd gear is only available in posi- selecting a forwards gear ⇒. tions D, 3 and 2 of the selector lever. Starting In positions 1 and R of the selector lever 1st gear and reverse gear are avail- Select a range (R, D, 3, 2, 1). Wait until the change has taken place and the able respectively as normal. power transmission of the drive wheels has stabilised (slight pressure is As the torque converter is required to work more, especially due to the lack of noticeable). Then depress the accelerator. 2nd gear, it is possible that the gearbox oil may overheat. In this case, consult Stopping the Authorised Service Centre as soon as possible. In the case of a temporary stop, for example at a traffic light, it is not neces- sary to move to position N, it is sufficient to brake using the brake pedal. The WARNING engine should only run at idle speed. • In all the ranges the vehicle must always be held with the foot brake Parking when the engine is running. This is because an automatic gearbox still On slopes, first pull handbrake on firmly and then connect block. This transmits power even at idling speed, and the vehicle tends to “creep”. prevents overloading of the locking mechanism, making the subsequent • If, when the car is at a standstill and the engine is idling, a range is deactivation easier ⇒. connected, take care not to accelerate accidentally (for example, when Emergency start working in the engine compartment), as the car will start to move immedi- ately. in vehicles fitted with an automatic gearbox the engine can not be started by • Before working on a running engine, place the selector lever in position towing or pushing the vehicle ⇒ page 224. P and apply the handbrake. If the vehicle battery is flat, a battery from another car can be used to jump-• To prevent the vehicle from moving out of control, the handbrake start the car using a set of jump leads ⇒ page 130.should always be applied when the vehi cle is at a standstill. In addition Towing move the selector lever to position P. If the vehicle requires towing at any time, observe the instructions of ⇒page224, “Towing and tow-starting”. Back-up programme In the event of a malfunction of the gearbox electronics, emergency programmes are activated, according to the type of fault. • The gearbox continues to connect gears automatically, but the operations are jerky. Consult the Authorised Service Centre. Safety First Operating instructions Tips and Maintenance Technical Data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders