owners manual Nissan Pathfinder

all ratings: 0 average rating: 5

● position the hand-held transmitter1-3 2. When the indicator light begins to flashFCCNotice: inches (26 - 76 mm) away from theslowly (after 20 seconds), position theFor USA: HomeLink surface. Hold the transmitter inhand-held transmitter1-3inches (26 - 76 that position for up to 15 seconds. Ifmm)awayfromtheHomeLinksurface.This device complies with Part 15 of the HomeLink is not programmed within that3. Press and hold the hand-held transmitterFCCRules. Operation is subject to the fol- time, try holding the transmitter in anotherbutton. lowing two conditions: (1) This device may position – keeping the indicator light in view notcauseharmfulinterference,and(2)this at all times. 4. TheHomeLinkindicatorlightwill flash, firstdevice must accept any interference re- slowly and then rapidly. When the indicatorceived, including interference that may If you continue to have programming difficulties,light begins to flash rapidly, release bothcauseundesiredoperation. Note: Changes please contact the NISSAN Consumer Affairsbuttons. ormodificationsnotexpresslyapprovedby Department. The phone numbers are located in thepartyresponsibleforcompliancecould the Foreword of this manual.TheHomeLinkUniversalTransceiverbuttonhasvoid the user’s authority to operate the CLEARINGTHEPROGRAMMED now been reprogrammed. The new device canequipment. INFORMATION be activated by pushing the HomeLink buttonFor Canada: that was just programmed. This procedure will Individual buttons cannot be cleared. However,not affect any other programmed HomeLinkThis device complies with RSS-210 of In- to clear all programming, press and hold the twobuttons.dustry Canada. Operation is subject to the outside buttons and release when the indicator following two conditions: (1) this device IF YOUR VEHICLE IS STOLEN may not cause interference, and (2) this light begins to flash (approximately 20 seconds). device must accept any interference, in- REPROGRAMMINGASINGLE If your vehicle is stolen, you should change thecluding interference that may cause unde- codes of any non-rolling code device that hassired operation of the device. HOMELINKBUTTON been programmed into HomeLink. Consult the ToreprogramaHomeLinkUniversalTransceiverOwner’sManualofeachdeviceorcallthemanu- button, complete the following.facturer or dealer of those devices for additional information. 1. Press and hold the desired HomeLink but-When your vehicle is recovered, you will ton. Do not release the button until step 4need to reprogram the HomeLink Univer- has been completed. sal Transceiver with your new transmitter information. 2-54 Instruments and controls

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders