owners manual Nissan Pathfinder

all ratings: 0 average rating: 5

grammed device, press and hold the pro-ton, quickly and firmly press and release theNOTE: grammed HomeLink button — releasingHomeLinkbuttonyou’ve just programmed.Whenprogrammingagaragedooropener, whenthedevice begins to activate.PressandreleasetheHomeLinkbuttonupetc., it is advised to unplug the device dur- 5. If the indicator light on the HomeLink blinksto 3 times to complete the training.ing the “cycling” process to prevent pos- rapidly for 2 seconds and then turns solid,8. Your HomeLinkbuttonshouldnowbepro-sible damage to the garage door opener HomeLink has picked up a “rolling code”grammed. (To program the remainingcomponents. garage door opener signal. You will need toHomeLink buttons for additional door orOPERATINGTHEHOMELINK proceed with the next steps to train thegate openers, follow steps 2-4 only.)UNIVERSALTRANSCEIVER HomeLink to complete the programming whichmayrequirealadderandanotherper-NOTE: TheHomeLinkUniversalTransceiver(oncepro- son for convenience. Do not repeat step 1 unless you want togrammed) may now be used to activate the ga- 6. Pressandreleasethe“smart”or“learn”pro-“clear”allpreviouslyprogrammedrage door, etc. To operate, simply press the ap- gram button located on the garage doorHomeLinkbuttons. propriate programmed HomeLink Universal opener’s motor to activate the “trainingIf you have any questions or are having difficultyTransceiver button. The red indicator light will mode”. This button is usually located nearprogramming your HomeLink buttons, refer toilluminate while the signal is being transmitted. the antenna wire that hangs down from thethe HomeLink web site at: www.homelink.comPROGRAMMINGTROUBLE- motor. If the wire originates from under aor call 1-800-355-3515.DIAGNOSIS light lens, you will need to remove the lens to access the program button. PROGRAMMINGHOMELINKFOR If the HomeLinkdoesnotquicklylearnthehand- NOTE: CANADIANCUSTOMERS held transmitter information: Once you have pressed and released thePrior to 1992, D.O.C. regulations required hand-● replace the hand-held transmitter batteries program button on the garage door open-heldtransmitters to stop transmitting after 2 sec-with new batteries. er’s motor and the “training light”is lit, youonds. To program your hand-held transmitter to● position the hand-held transmitter with its have30secondsinwhichtoperformstep7.HomeLink, continue to press and hold thebatteryareafacingawayfromthe Usethehelpofasecondpersonforconve-HomeLink button (see steps2-4under “Pro-HomeLink surface. niencetoassistwhenperformingthisstep.gramming HomeLink”) while you press and re- press(“cycle”) your hand-held transmitters every● press and hold both the HomeLink and 7. Within 30 seconds of pressing and releas-2secondsuntil the indicator light flashes rapidlyhand-held transmitter buttons without inter- ing the garage door opener’s program but-(indicating successful programming).ruption. Instruments and controls 2-53

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders