owners manual Nissan Altima

all ratings: 0 average rating: 5

NOTE: is difficulty locating the button, reference theIf you live in Canada or you are having difficulties Some devices may require you to replacegarage door opener’s manual. training a gate operator or garage door opener Step 2 with the cycling procedure noted in5. Pressandreleasethe“learn”or“smart”but-by using the “Training” procedures, replace “Programming HomeLink® for Canadian ton. “Programming HomeLink®”Step 2 with the fol- customers and gate openers” in this sec- lowing: tion. 6. Return to the vehicle and firmly press and hold the trained HomeLink® button forNOTE: 3. Press and hold the programmed 2 seconds and release. Repeat theWhenprogrammingagaragedooropener, HomeLink®button and observe the indica-“press/hold/release” sequence up to threeetc., unplug the device during the “cycling” tor light. times to complete the training process.process to prevent possible damage to the ● If the indicatorlight 1 is HomeLink®shouldnowactivateyourrollinggarage door opener components.  code equipped device. solid/continuous, programming is 1. For additional information, refer to “Program- complete and your device should acti-7. If you have any questions or are having diffi-ming HomeLink®”step 1 in this section. vate when the HomeLink® button is culty programming your HomeLink® but-2. Usingbothhands,simultaneouslypressand pressed and released. tons, refer to the HomeLink® web site at:holdthedesiredHomeLink®buttonandthe ● If the indicator light 1 blinks rapidly forwww.homelink.com or call 1-800-355-hand-held transmitter button. During train-  3515. ing, your hand-held transmitter may auto- 2 seconds and then turns to a matically stop transmitting. Continue to solid/continuouslight,continue PROGRAMMINGHOMELINK®FOR pressandholdthedesiredHomeLink®but- withSteps4-6forarollingcodedevice.CANADIANCUSTOMERSAND ton while you press and re-press (“cycle”) AsecondpersonmaymakethefollowingGATEOPENERS your hand-held transmitter every 2 seconds stepseasier.Usealadderorotherdevice. until the frequency signal has been learned. Do not stand on your vehicle to performCanadian radio-frequency laws require transmit-The HomeLink® indicator light will flash the next steps. ter signals to “time-out” (or quit) after severalslowlyandthenrapidlyafterseveralseconds 4. At the receiver located on the garage doorsecondsoftransmission–whichmaynotbelongupon successful training. DO NOT release opener motor in the garage, locate theenough for HomeLink® to pick up the signaluntil the HomeLink® indicator light flashes “learn”or“smart”button(thenameandcolorduring training. Similar to this Canadian law,slowly and then rapidly. When the indicator of the button may vary by manufacturer but itsome U.S. gate operators are designed to “tim-light flashes rapidly, both buttons may be is usually located near where the hangingeout”in the same manner. released. The rapid flashing indicates suc- antennawireisattachedtotheunit).If there cessful training. Instruments and controls 2-57

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders