owners manual Nissan Altima

all ratings: 0 average rating: 5

CLEARINGTHEPROGRAMMED 2. The indicator light will begin to flash afterFCCNotice: INFORMATION 20 seconds.WithoutreleasingtheFor USA: HomeLink® button, proceed with “Pro- The following procedure clears the programmedgramming HomeLink®”- Step 1.This device complies with Part 15 of the information from both buttons. Individual buttonsForquestionsorcomments,contactHomeLink®FCCRules. Operation is subject to the fol- cannot be cleared. However, individual buttonsat: www.homelink.com or 1–800–355–3515lowing two conditions: (1) This device may can be reprogrammed. See “Reprogramming a(except Mexico).notcauseharmfulinterference,and(2)this single HomeLink® button”in this section. device must accept any interference re- To clear all programming: The HomeLink® Universal Transceiver buttonceived, including interference that may has now been reprogrammed. The new devicecause undesired operation. 1. Press and hold the two outer HomeLink®can be activated by pushing the HomeLink® buttons until the indicator light begins tobuttonthatwasjustprogrammed.ThisprocedureNOTE: flash in approximately 10 seconds. Do notwill not affect any otherprogrammedHomeLink®Changesormodificationsnotexpresslyap- hold for longer than 20 seconds.buttons. provedbythepartyresponsibleforcompli- 2. Release both buttons. IF YOUR VEHICLE IS STOLEN ance could void the user’s authority to op- HomeLink® is now in the programming modeIf your vehicle is stolen, you should change theerate the equipment. and can be programmed at any time beginningcodes of any non-rolling code device that hasFor Canada: with “Programming HomeLink®”- Step 1.beenprogrammedintoHomeLink®.ConsulttheThis device complies with RSS-210 of In- REPROGRAMMINGASINGLE Owner’sManualofeachdeviceorcallthemanu-dustry Canada. Operation is subject to the HOMELINK®BUTTON facturer or dealer of those devices for additionalfollowing two conditions: (1) this device information. may not cause interference, and (2) this To reprogram a HomeLink® Universal Trans-When your vehicle is recovered, you willdevice must accept any interference, in- ceiver button, complete the following:needtoreprogramtheHomeLink®Univer-cluding interference that may cause unde- 1. PressandholdthedesiredHomeLink®but-sal Transceiver with your new transmittersired operation of the device. ton. DO NOT release the button.information. Instruments and controls 2-53

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders