owners manual Nissan Altima

all ratings: 0 average rating: 5

PROGRAMMINGHOMELINK®FOR pressandholdthedesiredHomeLink®but-PROGRAMMINGTROUBLE- CANADIANCUSTOMERSAND ton while you press and re-press (“cycle”)DIAGNOSIS GATEOPENERS your hand-held transmitter every two sec- onds until the frequency signal has beenIfthe HomeLink® does not quickly learn the Canadian radio-frequency laws require transmit-learned. The HomeLink® indicator light willhand-held transmitter information: ter signals to “time-out” (or quit) after severalflash slowly and then rapidly after several● replace the hand-held transmitter batteries secondsoftransmission–whichmaynotbelongsecondsuponsuccessfultraining. DO NOTwith new batteries. enough for HomeLink® to pick up the signalrelease until the HomeLink® indicator light during training. Similar to this Canadian law,flashes slowly and then rapidly. When the● position the hand-held transmitter with its some U.S. gate operators are designed to “tim-indicator light flashes rapidly, both buttonsbatteryareafacingawayfromthe eout”in the same manner. may be released. The rapid flashing indi-HomeLink®surface. cates successful training. ● press and hold both the HomeLink® and If you live in Canada or you are having difficultiesProceed with “Programming HomeLink®”hand-held transmitter buttons without inter- training a gate operator or garage door openerstep 3 to complete.ruption. by using the “Training” procedures, replaceIf the device was unplugged during the pro- “Programming HomeLink®”Step 2 with the fol-gramming procedure, remember to plug it● position the hand-held transmitter 1 - lowing: back in when programming is completed.3 inches (26 - 76 mm) away from the OPERATINGTHEHOMELINK® HomeLink®surface. Hold the transmitter in NOTE: that position for up to 15 seconds. If Whenprogrammingagaragedooropener,UNIVERSALTRANSCEIVER HomeLink® is not programmed within that etc., unplug the device during the “cycling”The HomeLink® Universal Transceiver, after it istime, try holding the transmitter in another process to prevent possible damage to theprogrammed, can be used to activate the pro-position – keeping the indicator light in view garage door opener components.grammed device. To operate, simply press andat all times. 1. See“ProgramingHomeLink®”step1earlierreleasetheappropriateprogrammedIf you have any questions or are having difficulty in this section. HomeLink® Universal Transceiver button. Theprogramming your HomeLink® buttons, refer to amberindicator light will illuminate while the sig-the HomeLink® web site at: www.homelink.com 2. Usingbothhands,simultaneouslypressandnal is being transmitted.or call 1-800-355-3515. holdthedesiredHomeLink®buttonandtheForconvenience,thehand-heldtransmitterofthe hand-held transmitter button. During train-device may also be used at any time. ing, your hand-held transmitter may auto- matically stop transmitting. Continue to 2-52 Instruments and controls

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders