owners manual Subaru Outback

all ratings: 0 average rating: 5

Keys and doors/Alarm system2-31 system will automatically arm and doorsNOTE &Tripped sensor identification will automatically lock. For models with “keyless access withThe security indicator light flashes when &Disarming the system push-button start system”, if the ac-the alarm system has been triggered. cesskeybatteryisdischarged,performAlso, the number of flashes indicates the Performeitherofthefollowing procedures.the procedure described in “Switchinglocation of unauthorized intrusion or the . Briefly press the disarm button (for lesspower” F9-18. In such a case, replaceseverity of impact on the vehicle. than 2 seconds) on the access key/remotethe battery immediately. Refer to “Re-When the ignition switch is turned to the transmitter. placing battery of access key” F11-49.“ON” position, the indicator light will . Carry the access key and perform illuminate for 1 second and then flash as either of the following procedures (models&Valet mode follows: with “keyless access with push-button . When a door or rear gate (Outback) start system”). When you choose the valet mode, the – Grip the front door handle.alarm system does not operate. In valetwas opened: 5 times – Press the rear gate opener button.mode, the access key/remote transmitter. When the trunk (Legacy) was opened: is used only for locking and unlocking the4 times The flashing of the security indicator lightdoors and rear gate (Outback) and panic. When a strong impact or multiple will then change slowly (once approxi-activation. impacts were sensed: twice (only models mately every 3 seconds from twice ap-To enter the valet mode, change thewith shock sensors (dealer option)) proximately every 2 seconds), indicatingsetting of your vehicle’s alarm system for. Whenalight impact was sensed: once that the alarm system has been disarmed.deactivation mode. Refer to “Activating(only models with shock sensors (dealer ! Emergency disarming and deactivating the alarm system” F2-option)) If you cannot disarm the system using the27. The security indicator light will con-&Shocksensors (dealer op- transmitter (i.e. the transmitter is lost,tinue to flash once every 3 seconds broken or the transmitter battery is tooindicating that the system is in the valettion) weak), you can disarm the system withoutmode. The shock sensors trigger the alarm using the transmitter. To exit valet mode, change the setting ofsystem when they sense impacts applied The system can be disarmed if you turnyour vehicle’s alarm system for activationto the vehicle and when any of their the ignition switch from the “LOCK”/“OFF”mode. Refer to “Activating and deactivat-electric wires is cut. The alarm system to the “ON” position with a registered key/ing the alarm system” F2-27.causes the horn to sound and the hazard access key. warning flashers to flash for a short time when the sensed impact is weak, but it warns of a strong impact or multiple – CONTINUED –

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders