Audi R8 I 1 owners manual page 13

text version of content this owner's manual page from owners manual to the vehicle Audi R8, year of production 2006 - 2015:

document_0900452a816e6cc9.book Seite 11 Mittwoch, 21. Februar 2007 1:32 13 Instruments and warning/indicator lamps 11 Rev counter different time zone, the hour display will need to be The rev counter indicates the number of engine revolu-adjusted manually to local time using the adjuster button. tions per minute. Setting the time zone You should select a lower gear if the engine speed drops below – Keep pulling the button ⇒ fig. 3 briefly until the time 1500rpm. The start of the red zone on the dial indicates the zone display flashes (select se tting “0” if you do not wish maximum engine speed which may be used briefly when the engine to change the time zone). is warm and after it has been run in properly. However, it is advisable to change up a gear or lift your f oot off the accelerator (or shift out – Then turn the button to the left (to set an earlier time of the R tronic sport mode) before the needle reaches the red zone.zone: -1/-2) or to the right (to set a later time zone: +1/+2). Caution Switching date display on and off Never allow the rev counter needle ⇒ page 10, fig. 2 2 to go into – Keep pulling the button briefly until the date display A flashes. the red zone on the scale for more than a very brief period: there is a risk of damaging the engine. The start of the red zone on the dial – Then turn the button to the left or right. is different for some engine versions. When the display stops flashing, this means the setting you are Radio-controlled clock performing is completed and the time zone has been successfully stored. If the clock does not receive a radio signal for three consecutive days, it will automatically switch to “quartz” mode. The signal recep- tion symbol will then disappear. If you need to reset the time and date, proceed as described on ⇒ page 12. Fig. 3 Detail of the instrument cluster: Display with signal reception symbol, time and date When the clock is in “radio-control” mode the signal recep- tion symbol (a radio tower with radio waves) appears in the display ⇒ fig. 3. It is then not possible to change the minutes or the date manually. If you take your vehicle into a Controls Safety Driving tips General maintenance Self-help Technical data

owners manual Audi R8

owners manual Audi R8 - year of production: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 - Audi R8 I 1 owners manual EN