Hyundai Genesis I 1 owners manual page 120

text version of content this owner's manual page from owners manual to the vehicle Hyundai Genesis, year of production 2008 - 2013:

Features of your vehicle Standard programming 6.To program the remaining two If there is difficulty locating the training ® HomeLink buttons, follow steps 2button, reference the device owner's To train most devices, follow these instructions: through 5. manual or please visit our Web site at 1. For first-time programming, press and www.homelink.com. hold the two outside bRolling code programming uttons, 2. Firmly press and release the "learn" or HomeLink® Channel 1 and Channel 3 "smart" button (which activates the Rolling code devices which are "code- Buttons, until the indicator light begins "training light"). protected" and manufactured after 1996 to flash (after 20 seconds).Release may be determined by the following: both buttons. Do not hold the buttons ✽✽ NOTICE for longer than 30 seconds. • Reference the device owner's manual for verification. There are 30 seconds in which to initiate 2. Position the end of your hand-held step3. • The handheld transmitter appears to transmitter 1-3 inches (2-8 cm) away ® program the HomeLinkUniversal ® buttons while from the HomeLink Transceiver but does not activate the keeping the indicator light in view. 3. Return to the vehicle and firmly press, device. hold for two seconds and then release 3. Simultaneously press and hold both the desired HomeLink ® button. Repeat • Press and hold the trained HomeLink ® the HomeLinkand hand-held trans- the "press/hold/release" sequence a mitter button.DO NOT release the but- button.The device has the rolling code feature if the indicator light flashes rap- second time to complete the program- tons until step 4 has been completed. ming. (Some devices may require you idly and then turns solid after 2 sec- 4.While continuing to hold the buttons to repeat this sequence a third time to onds. the red Indicator Status LED will flash complete the programming.) slowly and then rapidly after To train rolling code devices, follow these 4.Press and hold the just-trained HomeLink® successfully trains to the HomeLink®button and observe the red instructions: frequency signal from the hand-held Status Indicator LED. If the indicator transmitter. Release both buttons. 1. At the garage door opener receiver (motor-head unit) in the garage, locate light stays on constantly, programming 5.Press and hold the just-trained the "learn" or "smart" button. This can is complete and your device should HomeLink®button and observe the red activate. usually be found where the hanging Status Indicator LED. If the indicator 5.To program the remaining two antenna wire is attached to the motor- light stays on constantly, programming HomeLink® buttons, follow either steps head unit. Exact location and color of is complete and your device should 1 through 4 above for other Rolling ® button is the button may vary by garage door activate when the HomeLink opener brand. Code devices or steps 2 through 5 in pressed and released. Standard Programming for standard devices. 443

owners manual Hyundai Genesis

owners manual Hyundai Genesis - year of production: 2008, 2009, 2010, 2011, 2012, 2013 - Hyundai Genesis I 1 owners manual EN