owners manual Seat Leon

all ratings: 0 average rating: 5

Lights and visibility 115 Switching the main beam assist on and off WARNING effect use The convenience features of the main beam assist should not encourage – Switch the ignition on and turn the light switch to position the taking of risks. The system is not a replacement for driver concentra- . Activate: tion. – From the base position, move the main beam and turn signal ● You are always in control of the main beam and adapting it to the lever forwards ⇒ page 110. When the warning lamp  is dis-  light, visibility and traffic conditions. played on the instrument panel display, the main beam assist is switched on. ● It is possible that the main beam headlight control does not recog- nise all driving situations and is limited under certain circumstances. – Switch off the ignition. – OR: Turn the light switch to a different position to  ● When the field of vision of the camera is dirty, covered or damaged, To ⇒ page 111. operation of the main beam control may be affected. This also applies switch – OR: with main beam on, move the main beam and turn signal when changes are made to the vehicle lighting system, for example, if system lever backwards. additional headlights are installed. off: – OR: Move the main beam and turn signal lever forwards to manually switch main beam on. The main beam assist will then CAUTION be deactivated. To avoid affecting the operation of the system, take the following points in- Malfunctions to consideration: The following conditions may prevent the main beam headlight control from● Clean the field of vision of the camera regularly and make sure it is free turning off the headlights in time or from turning off altogether: of snow and ice. ● Do not cover the field of vision of the camera. ● In poorly lit towns with highly reflective signs. ● Check that the windscreen is not damaged in the area of the field of vi- ● Other insufficiently lit road users (such as pedestrians or cyclists). sion of the camera. ● On tight bends and steep slopes (bumps) and when oncoming vehicles are partially obscured. Note ● When the drivers of other oncoming vehicles (such as a truck) can see Main beam and headlight flasher can be turned on and off manually at any over a guard rail in the centre of the road.  time with the turn signal and main beam lever ⇒ page 110. ● If the camera is damaged or the power supply is cut off. ● In fog, snow and heavy rain. ● With dust and sand turbulence. Adjusting the headlights ● With loose gravel in the field of vision of the camera. ● When the field of vision of the camera is misted up, dirty or covered by The light beam of the dipped beam lights is asymmetric: the side of the stickers, snow, ice. road on which you are driving is lit more intensely.  Safety First Operating instructions Practical Tips Technical specifications

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders