owners manual Volvo XC70

all ratings: 0 average rating: 5

03 Instruments and controls || 3.Firmly press, hold for five seconds and Gate Operator/Canadian Programming release the programmed HomeLink but- Canadian radio-frequency laws require trans- ton up to two separate times to activate mitter signals to “time-out” (or quit) after sev- the door. If the door does not activate, eral seconds of transmission – which may not press and hold the just-trained HomeLink be long enough for HomeLink to pick up the button and observe the indicator light. signal during programming. Similar to this Canadian law, some U.S. gate operators are • If the indicator light stays on con- designed to “time-out” in the same manner. stantly, programming is complete and your device should activate when 03 If you live in Canada or you are having diffi- the HomeLink button is pressed and culties programming a gate operator or 4.At the garage door opener receiver released. garage door opener by using the “Program- (motor-head unit) in the garage, locate • If the indicator light blinks rapidly for ming” procedures, replace “Programming the “learn” or “smart” button. This can two seconds and then turns to a HomeLink” step 2 with the following: usually be found where the hanging constant light continue with “Pro- antenna wire is attached to the motor- • Continue to press and hold the HomeLink gramming” steps 4-6 to complete the head unit. button while you press and release - programming of a rolling code equip- every two seconds (“cycle”) your hand- 5.Firmly press and release the “learn” or ped device (most commonly a garage held transmitter until the HomeLink indi- “smart” button. (The name and color of door opener). cator light changes from a slow to a rap- the button may vary by manufacturer.) idly blinking light. Now you may release There are 30 seconds to initiate step 6. both the HomeLink and hand-held trans- 6.Return to the vehicle and firmly press,mitter buttons. hold for two seconds and release the pro- Proceed with “Programming” step 3 to com- grammed HomeLink button. Repeat the plete. “press/hold/release” sequence a second time, and, depending on the brand of theResetting HomeLink Buttons garage door opener (or other rolling code Use the following procedure to reset (erase equipped device), repeat this sequence a programming) from the three HomeLink but- third time to complete the programming tons (individual buttons cannot be reset but process. can be “reprogrammed” as outlined in the fol- lowing section): HomeLink should now activate your rolling code equipped device. 1.Press and hold the two outer HomeLink buttons until the indicator light begins to flash. 110

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders