owners manual Volvo XC70

all ratings: 0 average rating: 5

03 Instruments and controls ® Retain the original transmitter of the RF 2. Simultaneously press and hold both the HomeLink Wireless Control System* device you are programming for use in other chosen HomeLink and hand-held trans- – programming vehicles as well as for future HomeLink pro- mitter buttons until the HomeLink indica- The HomeLink Wireless Control System pro- gramming. It is also suggested that upon the tor light changes from a slow to a rapidly vides a convenient way to replace up to three sale of the vehicle, the programmed Home- blinking light. Now you may release both hand-held radio-frequency (RF) transmitters Link buttons be erased for security purposes. the HomeLink and hand-held transmitter used to activate devices such as gate opera- Refer to “Resetting HomeLink Buttons” in buttons. tors, garage door openers, entry door locks, ® HomeLink Wireless Control System* – pro- security systems, even home lighting. Addi- gramming (p. 109). NOTE tional information can be found on the Inter- 03 net atwww.homelink.com/www.youtube.com/ Some devices may require you to replace Using HomeLink HomeLinkGentex or by phoning the hotline at this Programming Step 2 with procedures To operate, simply press and hold the pro- 1–800–355–3515. noted in the “Gate Operator / Canadian grammed HomeLink button until the trained Programming” section. If the HomeLink device begins to operate (this may take sev- indicator light does not change to a rapidly NOTE eral seconds). Activation will now occur for blinking light after performing these steps, the trained device (i.e., garage door opener,Some vehicles may require the ignition to contact HomeLink at www.homelink.com/ be switched on or be in the “accessories” gate operator, security system, entry door www.youtube.com/HomeLinkGentex or by position for programming and/or operation phoning the hotline at 1–800–355–3515. lock, home/office lighting, etc.). For conven- of HomeLink. It is also recommended that ience, the hand-held transmitter of the device a new battery be placed in the hand-held may also be used at any time. In the event transmitter of the device being pro- that there are still programming difficulties or grammed to HomeLink for quicker training questions, contact HomeLink at: and accurate transmission of the radio-fre- www.homelink.com/www.youtube.com/ quency signal. The HomeLink buttons must be reset first. When this has been HomeLinkGentex or by phoning the hotline at completed, Homelink is in learning mode 1–800–355–3515. so that you can perform programming. NOTE 1. Position the end of your hand-held trans- If the ignition is switched off, HomeLink mitter 1–3 inches (5–14 cm) away from will function for 30 minutes after the driv- the HomeLink button you wish to pro- er's door has been opened. gram while keeping the indicator light in view. }} * Option/accessory, for more information, see Introduction.109

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders