Audi R8 I 1 owners manual page 99

text version of content this owner's manual page from owners manual to the vehicle Audi R8, year of production 2006 - 2015:

document_0900452a816e6cc9.book Seite 97 Mittwoch, 21. Februar 2007 1:32 13 HomeLink 97 Applies to vehicles: with HomeLink After programming at the operating unit, the garage door opener Rolling code programming should recognise the HomeLink signal and respond when the Some devices require rolling code programming of the HomeLink button is pressed. Now the other control buttons can be programmed as required. HomeLink universal transmitter. Identifying a rolling code Note – Press the already programmed HomeLink button again • Having a second person assist you makes programming of the and hold it down. rolling code easier and faster. For some makes of garage door openers the HomeLink button may have to be pressed a third time A –Watch HomeLink diode ⇒ page95, fig. 80. If the diode A to complete the training sequence. starts flashing rapidly and turns into a constant light • If you encounter problems programming the rolling code you after about 2 seconds, this indicates that the device you may find helpful information in the operating instructions of the wish to operate (e.g. a garage door opener) is equipped garage door opener or other device you wish to operate. with a rolling code. – Program the rolling code as follows: Applies to vehicles: with HomeLink Operating HomeLink Activating the garage door opener drive unit The programmed devices are activated by means of the – Locate the programming button on the garage door HomeLink control buttons above the interior mirror. drive. The exact location and colour of the button may vary depending on the type of garage door opener. – Switch on the ignition (do not start the engine). – Press the programming button on the door drive unit – Press the programmed HomeLink button ⇒ page 95, (this will normally cause a “programming mode indicator fig. 80. The device assigned to that button (e.g. garage lamp” on the unit to light up). You now have about 30 door) will be activated. seconds to start and complete programming of the HomeLink control button on the operating unit. The HomeLink indicator diode ⇒ page 95, fig. 80 will light up when you press the button. Programming of the operating unit above the interior mirror Applies to vehicles: with HomeLink – Press and release the already programmed HomeLink Erasing the HomeLink® button programming button. You can erase the complete HomeLink programming by – Press the HomeLink button again to complete rolling pressing the two outer buttons. code programming. – Switch on the ignition (do not start the engine). Controls Safety Driving tips General maintenance Self-help Technical data

owners manual Audi R8

owners manual Audi R8 - year of production: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 - Audi R8 I 1 owners manual EN