Nissan Patrol Y61 GR owners manual page 98

text version of content this owner's manual page from owners manual to the vehicle Nissan Patrol, year of production 1997:

ignition - Cold engine (cold weather) - key to START. accelerator pedal by turning the ignition - Cold engine (cold wea ther ) - the engine still does not start,repeat cranking Rel ease i tl e the accelerator pedal when the key to START. Relea se the key when the (not over 15 seconds at a time) until the engine [Outside temperature is below O°C (32°F)]: [Outside temperature is below 20°C engine starts. engine is clear of excess fuel. 3. Adj st the throttle (68°F) : control ] knob � until 1. Turn the ignition key to ON and wait until the the PULL and engine runs smoothly. pump the peda l. the If engine starts, but fails to run, repeat the Do not accelerator TURN to ind icator light ' goes out. 1. glow Turn the ignition key to ON and wait until th e above procedure. glow ind icator light ' goes out. lock 4. After the engine has warmed up, return the the pedal light 3. When the engine starts, release 2. Immediately after the giow ind icator throttle control knob to its original position. 3. Allow the engine to idle for about 30 sec gr adually as the engine speeds up. goes out, fully dep ress the accelerator pedal 2. Imme diately after the glow ind icator lig ht onds. goes out, crank the engine by turning and crank the engine by turning the ignition • Do not drive the vehicle with the th rot tle the ZD30D DTi DIESEL ENGINE key to START. and the ignition key to START. Release the key whe� Release the key control knob pull ed out. 4. TAP THE ACCEL ERATOR PEDAL TO RE accelerator pedal when the engine starts. Apply the parking brake. the engine starts. 1. DUCE THE ENGINE SPEED. The engine - Warm engine - ' 3. Adjust the throttle control knob until the will then warm up at normal speed. 2. Manual transmission: - Cold engine 1 . Turn the ignition key to ON and wait until the engine runs smoothly. (not cold wea ther ) - glow ind icator light ' goes out. Do not leave vehicle the while the engine is Move the gearshift lever to N (Neutral), and SD0051 4. After the engine has warmed up, turn the warming up. depr ess the clutch pedal to the floor while [Outside temperature is ab ove 20°C 2. Crank the engine by turning the ignition key throttle control knob counterclo ckwise to re (68°F)]: TD42/TD42Ti DI ESEL ENGI NE (with cranking the engine. to START. Release the key when the engine - Warm engine - it to its original turn position. thr ott le control knob) 1. Turn the ignition key to ON and wait until thl starts. Automatic transmis sion: 1. Depress the accelerator pedal about halfway glow indic ator light ' goes out. ' 1. Apply the parking brake. • Proper use of the th rottle control knob If it is difficult to res tat the engine imme Move the selector lever to P (Park) or N and hold it there. Do not pump the accelera will reduce start-up smoke. 2. Crank the engine by turning the ignition key 2. Move the gearshift lever to N (Neu tral), and diately after it has been sto pped because tor pedal. (Neutral). (P preferred) • Do not drive the vehicle with the th rottle to START. Release the key when the engine of high fuel temper atur e, ligh tly depr ess depress the clutch pedal to the floor while The starter is designed to not operate if control knob pul led out. 2. Crank the engine by turning the ignition key starts. the accelerator pedal. cran king the engine. the sel ecto r is in lever one the of driving to START. 3. Allow the engine to idle for about 30 sec - 3. Start the engine di fferent - Cold engine for conditions as positions. onds. 3. Release the key and the accelerator pedal listed below. (not cold wea ther ) - 3. Start the engine for dif ferent conditions as when the engine starts. - Warm engine - Do not oper ate the stater more for than 20 [Outside temperature is above O°C (32°F) ] : listed below. seco nds at a time. If the engine does not If the engine is flooded n 1. Turn the ignition key to ON and wait until the 1 . Turn the ignitio key to ON and wait until the Do not operate the stater for more than 20 sta t, wait 20 seconds before cra nking glow indic ator light ' goes out. glow ind icator light ' goes out. 1. Sl, owly depr ess the accelerator pedal to the . again, othewise the starter could be dam seconds at a time. If the engine does not floor. r 2. Crank the engine by turning the ignition key 2. Immediately after the glow indi cato light stat, wait 20 seconds before cra nking aged. to START. Release the key when the engine goes out, depress the accele rator pedal half again, othewise the stater could be dam 2. Keeping the pedal depressed, crank the en starts. way and crank the engine by turning the aged. gine by turning the ignition key to START. If Sta rting and driving 5-9 5-8 Sta rti ng and driving

owners manual Nissan Patrol

owners manual Nissan Patrol - year of production: 1997 - Nissan Patrol Y61 GR owners manual EN