owners manual Mercedes C

owners manual Mercedes C - year of production: 1993, 1994, 1995, 1996, 1997, 1998, 1999, 2000, 2001 - Mercedes Benz C Class W202 owners manual EN

Document: pdf (2.54 MB) 130 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Mercedes C, year of production 1993 - 2001:

Changing Wheels Move vehicle to a level area which is a safe distance from the road way. 1. Set parking brake and turn on hazard warning flasher. 2. Move selector lever to position "P" and turn off engine. 3. Prevent vehicle from rolling away by blocking wheels with wheel chocks (not supplied with vehicle) or sizable wood block or stone. When changing a wheel on a hill, pl ace chocks on the downhill side blocking both wheels of the other axle. On a level road, place one chock in front of and one behind the wheel that is diagonally opposite to the wheel being changed. 4. Using the wrench, loosen but do not yet remove the wheel bolts. 5. Remove the protective cover from the jack support tube opening by inserting the screwdriver (supplied in the tool kit) in the opening and prying it out. The tube openings are located directly behind the front wheel housings and in front of the rear wheel housings. 6. Insert jack arm fully into the tube hole up to the stop. Place jack on firm ground. Position the jack so that it is always vertical (plumb-line) as seen from the side (see arrow), even if the vehicle is parked on an incline. 7. Jack up the vehicle until the wheel is clear of the ground. Never start engine while vehicle is raised. 8. Unscrew upper-most wheel bolt and install alignment bolt (1) supplied in the tool kit. Remove the remaining bolts. Keep bolt threads protected from dirt and sand. 9. Remove wheel. Grip wheel from the sides. Keep hands from beneath the wheels. 10.Clean contact surfaces of wheel and wheel hub. Install spare wheel on wheel hub. Insert wheel bolts and tighten them slightly. To avoid paint damage, place wheel flat against hub and hold it there while installing first wheel bolt. Unscrew the alignment bolt (1) to install the last wheel bolt. 11.Lower car. Remove jack and insert jack tube cover. Before storing the jack, the jack arm m ust be lowered almost to the base of the jack. Warning ! Always replace wheel bolts that are damaged or rusted. Never apply oil or grease to wheel bolts. Damaged wheel hub threads should be repaired immediately. Incorrect mounting bolts or improperly tightened mounting bolts can cause the wheel to come off. This could cause an accident. Be sure to use the correct mounting bolts. 12. Using the wrench, tighten the five bolts evenly, followin g the sequence illustrated, until all bolts are tight. Observ e a tightening torque of 80 ft.lb. (110 Nm). 13. Ensure proper tire pressure.

Download PDF

Click here to download a pdf file with an instruction manual for Mercedes C
year of production from: 1993

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.