owners manual Nissan Note

all ratings: 1 average rating: 5

The may also come on steady if the fuel-● MILonsteady—AnemissioncontrolsystemCAUTION filler cap is loose or missing, or if the vehicle runsmalfunction has been detected. Check the out of fuel. Check to make sure the fuel-filler capfuel-filler cap. If the LOOSE FUEL CAPContinued vehicle operation without hav- is installed and closed tightly, and that the vehiclewarning message is displayed in the odom-ing the emission control system checked has at least 3 gal (11.4 L) of fuel in the fuel tank.eter, and the fuel-filler cap is loose or miss-and repaired as necessary could lead to ing, tighten or install the cap and continue topoor driveability, reduced fuel economy, After a few driving trips, thelight shoulddrive the vehicle. Thelight should turnandpossibledamagetotheemissioncon- turn off if no other potential emission controloff after a few driving trips. If thelighttrol system. system malfunction exists.does not turn off after a few driving trips,Overdrive OFF indicator light If this indicator light comes on steady for 20 sec-have the vehicle inspected by a NISSAN(CVTmodels) (if so equipped) onds and then blinks for 10 seconds when thedealer. You do not need to have your vehicle engine is not running, it indicates that the vehicletowed to the dealer.The overdrive OFF indicator light illuminates is not ready for an emission control system● MIL blinking — An engine misfire has beenwhentheoverdrive off mode is selected. inspection/maintenancetest.See“Readinessfordetected which may damage the emissionFor additional information, see “Continuously inspection/maintenance (I/M) test” in the “Tech-control system. To reduce or avoid emissionVariable Transmission (CVT)”inthe“Startingand nical and consumer information” section of thiscontrol system damage:driving” section of this manual. manual. Security indicator light Operation – do not drive at speeds above 45 MPH (72 km/h); The MIL will come on in one of two ways:– avoid hard acceleration or deceleration;For vehicles without Intelligent Key: This light blinks whenever the ignition switch is placed in – avoid steep uphill grades;the LOCK, OFF or ACC position. – if possible, reduce the amount of cargoFor vehicles with Intelligent Key: This light blinks being hauled. when the ignition switch is placed in the LOCK The MIL may stop blinking and come on steady.position with the key removed from the ignition Havethevehicle inspected by a NISSAN dealer.switch. YoudonotneedtohaveyourvehicletowedtotheTheblinking security indicator light indicates that dealer. the security systems equipped on the vehicle are operational. Instruments and controls 2-19

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders