owners manual Nissan Altima

all ratings: 0 average rating: 5

The high beam indicator light also comes onOperationTheMalfunctionIndicatorLightmaystopblinking whenthepassing signal is activated.The Malfunction Indicator Light will come on inandcomeonsteady.Havethevehicleinspected Malfunction Indicator Lightone of two ways:by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. (MIL) ● Malfunction Indicator Light on steady — An If this indicator light comes on steady or blinksemission control system malfunction hasCAUTION while the engine is running, it may indicate abeen detected. Check the fuel-filler cap ifContinued vehicle operation without hav- potential emission control malfunction.the LOOSE FUEL CAP warning appears ining the emission control system checked the vehicle information display. If the fuel-and repaired as necessary could lead to The Malfunction Indicator Light may also comefiller cap is loose or missing, tighten or installpoor driveability, reduced fuel economy, onsteadyif the fuel-filler cap is loose or missing,the cap and continue to drive the vehicle.andpossibledamagetotheemissioncon- or if the vehicle runs out of fuel. Check to makeThelight should turn off after a fewtrol system. sure the fuel-filler cap is installed and closeddriving trips. If thelight does not turnOverdrive OFF indicator light (if tightly, and that the vehicle has at least 3 gallonsoff after a few driving trips, have the vehicle (11.4 liters) of fuel in the fuel tank.inspected by a NISSAN dealer. You do notso equipped) need to have your vehicle towed to the After a few driving trips, thelight shoulddealer.QR25DE: turn off if no other potential emission control● Malfunction Indicator Light blinking — AnThe overdrive off indicator light illuminates when system malfunction exists.enginemisfirehasbeendetectedwhichmaythe overdrive off mode is selected. If this indicator light comes on steady for 20 sec-damagetheemissioncontrol system. To re-VQ35DE: onds and then blinks for 10 seconds when theduceoravoidemissioncontrolsystemdam- engine is not running, it indicates that the vehicleage:This light illuminates and then turns off when the is not ready for an emission control system– do not drive at speeds above 45 MPHignition switch is placed to the ON position. inspection/maintenancetest.See“Readinessfor(72 km/h).QR25DEandVQ35DE: inspection/maintenance (I/M) test” in the “Tech-– avoid hard acceleration or deceleration. nical and consumer information” section of thisFor additional information, see “Continuously manual. – avoid steep uphill grades.Variable Transmission (CVT)”inthe“Startingand – if possible, reduce the amount of cargodriving” section of this manual. being hauled or towed. Instruments and controls 2-15

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders