Mitsubishi Lancer VIII 8 owners manual page 89

text version of content this owner's manual page from owners manual to the vehicle Mitsubishi Lancer, year of production 2007 - 2016:

Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped) 2.While depressing the brake pedal on vehi- 5.While pushing the ignition switch from Startability of continuously variable “LOCK” (PUSH OFF) to “LOCK”cles equipped with continuously variable transmission (CVT) vehicles or Twin (PUSH ON), set the ignition switch to the transmission (CVT) or Twin Clutch SST Clutch SST vehicles at extremely cold or the clutch pedal on the vehicles “ON” position and confirm that all warn- ambient temperature ing lights and warning displays are operequipped with manual transaxle, press the- ating properly. accelerator pedal halfway and hold it When the ambient temperature is -4°F there, then crank the engine. Release the 6.Without pressing the accelerator pedal, (-20°C) or lower on vehicles with CVT, or slowly turn the ignition switch to theaccelerator pedal, immediately after the 5 -22°F (-30°C) or lower on vehicles with Twin engine starts. “START” position to start the engine. Clutch SST, it may not be possible to start Release the ignition switch when the3.If the engine still will not start, the engine from a standstill even with the selector lever engine starts. could be flooded with too much gasoline. (CVT) or the gearshift lever (Twin Clutch While depressing the brake pedal on vehi-SST) in the “D” (DRIVE) position. NOTE cles equipped with CVT or Twin Clutch This phenomenon occurs because the trans- SST or the clutch pedal on the vehicles Minor noises may be heard on engine start- axle has not warmed up sufficiently; it does equipped with manual transaxle, push the up. These will disappear as the engine warms not indicate a problem. If this occurs, place up. accelerator pedal all the way down and the selector lever (CVT) or the gearshift lever hold it there, then crank the engine for 5 When the engine is hard to startto 6 seconds. Return the ignition switch to(Twin Clutch SST) in the “P” (PARK) posi- tion and let the engine idle for at least 10 min- the “LOCK” position and release the accelerator pedal. Wait a few seconds, andutes. After several attempts, you may experience that the engine still does not start.then crank the engine again for 5 to 6 sec- The transaxle will warm up, and you will be able to drive normally. onds while depressing the brake pedal or 1.Make sure that all electric devices, such Do not leave the vehicle during warm-up the clutch pedal, but do not push the as lights, air conditioning blower and rear operation. accelerator pedal. Release the ignition key window defogger, are turned off.if the engine starts. If the engine fails to start, repeat these procedures. If the engine still will not start, contact your local Mitsubishi Motors dealer or a repair facility of your choice for assistance. 5-22 Features and controls

owners manual Mitsubishi Lancer

owners manual Mitsubishi Lancer - year of production: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016 - Mitsubishi Lancer VIII 8 owners manual EN