Volvo V50 owners manual page 88

text version of content this owner's manual page from owners manual to the vehicle Volvo V50, year of production 2004 - 2012:

2007 Volvo V50 Some garage door openers may require you to replace step 3 with the "cycling" procedure noted in the "Programming the transceiver for the first time (Canadian residents)" section. 4. Press and hold the trained HomeLink button and observe the indicator light. ● If the indicator light is solid/continuous, training is complete and your device should activate when the HomeLink button is pressed and released. ● If the indicator light blinks rapidly for 2 seconds and then turns a solid/continuous light, proceed with the following training instructions for a rolling code device. A second person may make the following steps quicker and easier. Please use a ladder or other device. Do not stand on your vehicle to perform the next steps. 5. At the garage door opener receiver (motorhead unit) in the garage, locate the "learn" or "smart" button (usually near where the hanging antenna wire is attached to the unit). If there is difficulty locating the training button, reference the garage door opener's manual or contact us toll-free 1-800-355-3515 (Internet: www.HomeLink.com). 6. Press and release the "learn" or "smart" button (the name and color of the button may vary by manufacturer). NOTE Once the button is pressed, there are 30 seconds in which to initiate the next step. 7. Return to the vehicle and firmly press and hold the trained HomeLink button for two seconds and release. Repeat the "press/ hold/release" sequence up to 3 times to complete the training process. To train additional HomeLink buttons, begin with step two. Programming the transceiver for the first time (Canadian residents) 1. For first time training, press and hold the two outer HomeLink buttons releasing only when the HomeLink indicator light begins to flash after 20 seconds. (Do not perform this step when training the additional HomeLink buttons.) 2. Position the hand-held transmitter 1-3 inches (2.5-7.5 cm) away from the HomeLink surface (located on your) keeping the HomeLink indicator light in view. 3. Using both hands, simultaneously press and hold both the desired HomeLink button and hand held transmitter button. During programming, your handheld transmitter may automatically stop transmitting. Continue to press and hold the desired HomeLink button while you press and re-press ("cycle") your handheld transmitter every two seconds until the frequency signal has been learned. The indicator light will flash slowly and then rapidly after several seconds upon successful training. DO NOT release until the HomeLink indicator light flashes slowly and then rapidly. When the indicator light flashes rapidly, both buttons may be released. (The rapid flashing indicates successful training.) 80 02 Instruments and controls Home Link® Universal Transceiver (option) 4. Press and hold the trained HomeLink button and observe the indicator light. ● If the indicator light is solid/continuous, training is complete and your device should activate when the HomeLink button is pressed and released. ● If the indicator light blinks rapidly for 2 seconds and then turns a solid/continuous light, proceed with the following training file:///K|/ownersdocs/2007/2007_V50/07v50_02.htm (38 of 40)12/30/2006 5:48:29 PM

owners manual Volvo V50

owners manual Volvo V50 - year of production: 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012 - Volvo V50 owners manual EN