owners manual Volvo C30

all ratings: 0 average rating: 5

02 Instruments and controls HomeLink® Wireless Control System* NOTE found where the hanging antenna wire iscedures, replace “Programming HomeLink” Some devices may require you to replaceattached to the motor-head unit.step 2 with the following: 5.Firmly press and release the “learn” or• Continue to press and hold the HomeLink02 this Programming Step 2 with procedures noted in the “Gate Operator / Canadian Pro-“smart” button. (The name and color of thebutton while you press and release - gramming” section. If the HomeLink indica-button may vary by manufacturer.) Thereevery two seconds (“cycle”) your hand- tor light does not change to a rapidly blink-are 30 seconds to initiate step 6.held transmitter until the HomeLink indica- ing light after performing these steps, con-6.Return to the vehicle and firmly press, holdtor light changes from a slow to a rapidly tact HomeLink at www.homelink.com. blinking light. Now you may release both for two seconds and release the pro-the HomeLink and hand-held transmitter 3.Firmly press, hold for five seconds andgrammed HomeLink button. Repeat thebuttons. release the programmed HomeLink but-“press/hold/release” sequence a secondProceed with “Programming” step 3 to com- ton up to two separate times to activate thetime, and, depending on the brand of theplete. door. If the door does not activate, pressgarage door opener (or other rolling code and hold the just-trained HomeLink buttonequipped device), repeat this sequence a and observe the indicator light.third time to complete the programmingUsing HomeLink process. To operate, simply press and release the pro- • If the indicator light stays on con-HomeLink should now activate your rollinggrammed HomeLink button. Activation will stantly, programming is completecode equipped device.now occur for the trained device (i.e., garage and your device should activate when door opener, gate operator, security system, the HomeLink button is pressed andGate Operator/Canadian Programmingentry door lock, home/office lighting, etc.). For released. Canadian radio-frequency laws require trans-convenience, the hand-held transmitter of the • If the indicator light blinks rapidly formitter signals to “time-out” (or quit) after sev-device may also be used at any time. In the two seconds and then turns to a con-eral seconds of transmission – which may notevent that there are still programming difficul- stant light continue with “Program-be long enough for HomeLink to pick up theties or questions, contact HomeLink at: ming” steps 4-6 to complete the pro-signal during programming. Similar to thiswww.homelink.com. gramming of a rolling code equippedCanadian law, some U.S. gate operators are device (most commonly a garage doordesigned to “time-out” in the same manner. opener). 4.At the garage door opener receiver (motor-If you live in Canada or you are having difficul- head unit) in the garage, locate the “learn”ties programming a gate operator or garage or “smart” button. This can usually bedoor opener by using the “Programming” pro-  * Option/accessory, for more information, see Introduction.87

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders