owners manual VW Passat

all ratings: 0 average rating: 5

Please carry out each step only in the order specified: At the garage door opener receiver (overhead unit) in the garage, locate the “learn” or 5. “training” button. The name and color of the button may vary by manufacturer. This button is usually located near the hanging antenna wire attachment point on the unit. If you cannot locate the “training” button, refer to the garage door opener’s user manual. 6. Press and release the “training” button. Once the button is pressed, you have 30 seconds to initiate the next step. 7. Return to the vehicle. Firmly press and hold the programmed garage door opener button on the sun visor keypad for 2 seconds and release. 8. Repeat the “press/hold/release” sequence up to 3 times to complete the programming process for that button. Repeat the steps to program the other garage door opener buttons on the sun visor keypad to control other devices. Deleting programming for all buttons Be sure to delete programming on all buttons on the sun visor keypad before selling the vehicle or turning it over to people you do not know. x Complete the programming preparation steps described above. x Press and hold buttons 1 and 3 at te same htime, for about 20 seconds. x When the indicator light above button 2 begins to flash, immediately release buttos n1 and 3. This step deletes all old settings. After programming Test the garage door opener, Operating the garage door opener. Applicable only in Mexico and the AGCC Operating the garage door opener ¤ Please first read and note the introductory information and heed the WARNINGS . The vehicle must be in operating range of the garage or outer gate drives. x With ignition turned on or engine running, press the appropriate button on the sun visor eykpad ⇒  . The range of the garage door opener in the vehicle roughly corresponds to the range of the original remote control of the device or the electrical drive. If the garage door or the electrical drive does not work, this could be for one of the following reasons: Malfunction Possible cause Possible remedy Garage door or electrical Distance or transmission Try different distances and angles to the drive does not work angle too great. receiver. Garage door or electrical May not comply with legal requirements drive not compatible. and may have to be replaced. Incorrect programming. Reprogram garage door opener.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders