Mini Clubman owners manual page 86

text version of content this owner's manual page from owners manual to the vehicle Mini Clubman, year of production 2007:

CONTROLS Practical interior accessories Canada: if the LED is not flashing rapidly 1.Park your vehicle within the range of the after 60 seconds, change the distance and remote-controlled device. repeat the step or, if the programming was Do not exceed the 164 ft/50 m range interrupted by the hand-held transmitter, of the remote-controlled device. press and hold the memory button and 2.Program the integrated universal remote press the button on the hand-held transmit-control as described above in the section ter for 2 seconds and release several times.Fixed-code hand-held transmitters. 5.To program other original hand-held trans-3.Locate the button on the receiver of the mitters, repeat steps 3 and 4. device to be set, e.g. on the drive unit. The corresponding memory button1 is now 4.Press the button on the receiver of the programmed with the signal of the original device to be set. After Step 4, there remain hand-held transmitter. approx. 30 seconds for Step 5. You can operate the system with the engine 5.Press and hold the programmed memory running or with the ignition switched on.button1 on the integrated universal remote If the system fails to function even after control for approx. 3 seconds. repeated programming, check whether If necessary, repeat the step up to three the original hand-held transmitter uses an alter-times. nating-code system. To do so, either read the The corresponding memory button1 is now instructions for the original hand-held transmit-programmed with the signal of the original ter or hold down the programmed memory hand-held transmitter. button1 of the integrated universal remote con- trol. If the LED 2 for the integrated universal Clearing stored programs remote control quickly flashes for a short period of time and is then continuously on, then the Press both outer memory buttons1 for approx. original hand-held transmitter is equipped with 20seconds until the LED2 flashes: all stored an alternating-code system. If it uses an alter-programs are cleared. nating-code system, program the memory It is not possible to clear individual programs. buttons1 as described under Alternating-code hand-held transmitters.< Reassigning individual programs Alternating-code hand-held 1.Hold the original hand-held transmitter at a transmitters distance of approx. 1in/2.5cm to 3in/8cm from the memory buttons1. To program the integrated universal remote The required distance between the control, consult the operating instructions for hand-held transmitter and the mem- the device to be set. You will find information ory buttons 1 depends on the system of the there on the possibilities for synchronization or respective original hand-held transmitter programming of additional hand-held transmit-used.< ters. 2.Press the desired memory button1 of the When programming hand-held transmitters that integrated universal remote control. employ an alternating code, please observe the following supplementary instructions:If the LED 2 flashes slowly after approx. Programming will be easier with the aid of 20seconds, press the transmit key of the a second person.< original hand-held transmitter and release both buttons as soon as the LED 2 flashes rapidly. 84 Online Online Edition Edition for for Part Part no. no. 01 01 40 40 2 2 607 607 326 326 - - © © 03/11 03/11 BMW BMW AGAG

owners manual Mini Clubman

owners manual Mini Clubman - year of production: 2007 - Mini Clubman owners manual EN