Nissan Juke owners manual page 83

text version of content this owner's manual page from owners manual to the vehicle Nissan Juke, year of production 2010:

Black plate (81,1) Cruise malfunction: pushing the ignition switch with the brake pedalmaintenance test. (See “READINESS FOR Ifthe cruise indicator light blinks while thedepressed. You can start the engine directly inINSPECTION/MAINTENANCE (I/M) TEST” in engine is running, it may indicate the cruiseany position.the “9. Technical and consumer information” control system is not functioning properly. Have section.) the system checked by a NISSAN dealer.High beam indicator lightOperation: See “CRUISE CONTROL” in the “5. StartingThis light illuminates when the headlight highThe malfunction indicator light will illuminate in and driving” section. beam is on and goes out when the low beam isone of two ways: selected. . Malfunction indicator light illuminated steady Front passenger air bag status —Anemission control system and/or CVT light Malfunction Indicator Light (MIL)malfunction has been detected. Check the Ifthe malfunction indicator light illuminatesfuel-fillercap if the LOOSE FUEL CAP The front passenger air bag status light (located warning message is displayed on the twin on the center of the instrument panel) will be litsteady or blinks while the engine is running, ittrip odometer. If the fuel-filler cap is loose or and the passenger front air bag will be OFFmay indicate a potential emission control and/ormissing, tighten or install the cap and depending on how the front passenger seat isContinuously Variable Transmission (CVT) mal-continue to drive the vehicle. Thelight being used. function. should turn off after a few driving trips. If the For front passenger air bag status light opera-The malfunction indicator light may also illumi-light does not turn off after a few nate steady if the fuel-filler cap is loose ordriving trips, have the vehicle inspected by a tion,see“NISSANADVANCEDAIRBAG NISSAN dealer. You do not need to have SYSTEM (front seats)” in the “1. Safety —missing, or if the vehicle runs out of fuel. Check Seats, seat belts and supplemental restraintto make sure the fuel-filler cap is installed andyour vehicle towed to the dealer. system” section of this manual.closed tightly, and that the vehicle has at least 3.Malfunction indicator light blinking — An USgallons (11.4 liters) of fuel in the fuel tank.engine misfire has been detected which may Engine start operation indicatorAfter a few driving trips, thelight shoulddamage the emission control system. light (if so equipped) turn off if no other potential emission controlTo reduce or avoid emission control system system malfunction exists. damage: This light appears when the selector lever is inIf this indicator light remains on for 20 seconds the P (Park) position (Continuously Variableand then blinks for 10 seconds when the enginea) Do not drive at speeds above 45 MPH Transmission (CVT) models) or N (Neutral)is not running, it indicates that the vehicle is not(72 km/h). position (Manual Transmission (MT) models).ready for an emission control system inspection/b) Avoid hard acceleration or deceleration. This light means that the engine will start by Instruments and controls 2-17 Model "F15-D" EDITED: 2011/ 5/ 11

owners manual Nissan Juke

owners manual Nissan Juke - year of production: 2010 - Nissan Juke owners manual EN