VW Jetta VI 6 owners manual page 76

text version of content this owner's manual page from owners manual to the vehicle VW Jetta, year of production 2010:

Please carry out each step only in the order specified: Press and hold the programmed HomeLink button and watch the indicator light. If the indicator light comes on and does not flash, programming is complete and your garage door opener or other device should activate when the HomeLink button is pressed and released. 4. If the indicator light blinks rapidly for 2 seconds and then stays on, proceed with the follow- ing programming instructions for a rolling code device. A second person may make the following steps quicker and easier. Please use a ladder or other device. Do not stand on your vehicle to perform the next steps ⇒ in Operating the HomeLink® Universal Transmitter At the garage door opener receiver (overhead unit) in the garage, locate the “learn” or 5. “training” button. The name and color of the button may vary by manufacturer. This button is usually located near the hanging antenna wire attachment point on the unit. If you cannot locate the “training” button, refer to the garage door opener’s user manual. 6. Press and release the “training” button. Once the button is pressed, you have 30 seconds to initiate the next step. 7. Return to the vehicle. Firmly press and hold the programmed HomeLink button for 2 se- conds and release. 8. Repeat the “press/hold/release” sequence up to 3 times to complete the programming process for that button. ® Repeat the steps to program the other buttons for the HomeLink Universal Transmitter on the sun visor keypad to control other devices. Deleting programming for all buttons Be sure to delete programming on all buttons on the sun visor keypad before selling the vehicle or turning it over to people you do not know. x Complete the programming preparation steps described above. x Press and hold buttons 1 and 3 at the same time, for about 20 seconds. x When the indicator light above button 2 begins to flash, immediately release buttons 1 and 3. This step deletes all old settings. After programming Test the garage door opener ® Operating the HomeLink Universal Transmitter ¤ Please first read and note the introductory information and heed the WARNINGS x The vehicle must be in operating range of the garage or outer gate drives. x With ignition turned on or engine running, press the appropriate button on the sun viso⇒ r . ® The range of the HomeLink Universal Transmitter roughly corresponds to the range of the original remote control of the device or the electrical drive. If the garage door or the electrical drive does not work, this could be for one of the following reasons:

owners manual VW Jetta

owners manual VW Jetta - year of production: 2010 - VW Jetta VI 6 owners manual EN