owners manual Skoda Octavia

all ratings: 0 average rating: 5

20A5Facelift.book Page 71 Saturday, September 6, 2008 2:13 PM Lights and Visibility71 The headlight washer nozzles are moved forward out of the bumper by the water WARNING pressure for cleaning the headlights. • Properly maintained windscreen wiper blades are essential for clear visi-You should remove stubborn dirt (such as insect residues) from the headlight bility and safe driving ⇒page71. lenses at regular intervals, for example when refuelling. Please refer to the following • Do not use the windscreen washer system at low temperatures, without guidelines ⇒page214, “The headlight lenses”. heating the windscreen beforehand. Otherwise the window cleaner could You should remove any snow from the fixtures of the washer nozzles and clear ice freeze on the windscreen and restrict the view to the front. in winter with a de-icing spray in order to ensure proper operation of the cleaning • The rain sensor only operates as a support. The driver is not released system. from the responsibility to set the function of the windscreen wipers manu- ally depending on the visibility conditions. Replacing wiper blades for the windscreen wipers Caution In frosty weather, please first of all check whether the windscreen wiper blades are not frozen to the windscreen before switching them on. Switching on windscreen wipers when the blades are frozen to the windscreen may result in damage both to the blades and the motor of the windscreen wipers! Note • If the slower 2 or the faster 3 wiper setting is switched on ⇒ page 69, fig. 70 A A and the vehicle speed decreases to below 4 km/h, the lower wiper step is switched Fig. 71 Wiper blade for the on automatically. At a speed increase of more than 8 km/h the previous wiper windscreen wiper setting is established again. • If there is an obstacle on the windscreen, the wiper will try to push away the One cannot fold out the wiper arms in the rest position from the wind- obstacle. If the obstacle continues to block the wiper, the wiper stops after 5 cycles, screen. Before replacing the wiper arms you must put them into the in order to avoid a damage to the wiper. Remove the obstacle and and switch on service position. the wiper again. Service position for changing wiper blades Headlight cleaning system* – Close the bonnet. The headlights are being cleaned after the windscreen has been sprayed for the first – Switch the ignition on and then again off. time and fifth time, the low beam or main beam are switched on and the wind-– Then press the windscreen wiper lever in the position 4 ⇒ page 69, A 5 screen wiper lever was held in the position A ⇒page69, fig.70 for about 1 fig. 70 within 20 seconds - the wiper arms move into the service posi- second. tion. Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders