owners manual Seat Ibiza

all ratings: 0 average rating: 5

Cockpit 69 There is a fault in the ABS if: Bulb defect*  ● The control lamp  does not light up when the ignition is switched on. The indicator lights up when a bulb is not functioning. ● The control lamp does not go out again after a few seconds. ● The control lamp lights up when the vehicle is moving. The  warning lamp lights up when there is a fault on the turn signals,  headlights, side lights and fog lights. The vehicle can still be braked in the normal way, without the ABS function. Take the vehicle to a specialised workshop as soon as possible. For further information on the ABS go to ⇒ page 168. Washer fluid  If there is a fault in the ABS, the ESC* and the tyre pressure control lamp will also light up. This warning lamp lights up to indicate that the windscreen Brake system fault washer level is too low. If the ABS warning lamp  lights up together with the brake warning lamp This serves as a reminder to fill up the reservoir at the earliest opportunity, this indicates not only a fault in the ABS function, but also a possible  ⇒ page 208. fault in the brake system ⇒ . WARNING Rear fog light*  ● Before opening the bonnet, read and observe the warnings on ⇒ page 199, Working in the engine compartment. This warning lamp lights up when the rear fog light is switched on . For ● If the brake system warning lamp  should light up together with the  further information see ⇒ page 98. ABS warning lamp , stop the vehicle immediately and check the brake fluid level in the reservoir ⇒ page 212, Brake fluid. If the brake fluid lev- el has dropped below the “MIN” mark you must not drive on. Risk of acci- dent. Obtain technical assistance. Anti-lock brake system (ABS)*  ● If the brake fluid level is correct, the fault in the brake system may have been caused by a failure of the ABS system. This could cause the A control lamp monitors the ABS. rear wheels to lock quickly when you brake. This could cause the rear to break away. Risk of skidding. Stop the vehicle and seek technical assis- The control lamp  should light up for a few seconds when the ignition is tance.  switched on. It goes out again after the system has run through an automat- ic test sequence. Safety First Operating instructions Practical Tips Technical Specifications

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders