owners manual Saab 9-3

all ratings: 0 average rating: 5

Instruments and controls71 Calculation of arrival time and Using DIST as a trip meter To calculate the arrival time if a specified average speed If no value has been set for the DIST func-average speed is maintained The settings must be made before the jour-tion, DIST will now function as a trip meter ney is started. (indicated by an arrow on the far right of the 1 Select DIST using the button. display). 2 Hold the SET button for two seconds. Calculation of arrival time: Press CLR to reset the trip meter.3 Set the distance to be covered using Under 1000 miles the distance will be 1 Select DIST using the button.shown in increments of 0.1 miles, or . 2 Hold SET until display starts flashing.there-after, the reading will change in incre-4 Press SET to store settings. ments of 1.0 miles. 3 Set the destination distance using or Metric units: for just under a kilometer, the 5 Press to select SPD Ø. . distance will be shown in increments of 6 Hold the SET button for two seconds. 4 Press SET to store settings. 10 meters, there-after, the reading will 7 Set the average speed you intend to When ARRIV is selected during the journey, change in increments of 100 meters. the arrival time based on the average speed When DIST is functioning as a trip meter, drive at using or . over the past 20 minutes will be displayed. the ARRIV function will display the current 8 Press SET to display the estimated The trip computer will include any stops in time. arrival time. the calculation of the estimated time of At the beginning of a journey, the SPD Ø arrival. and ARRIV functions will display current Press DIST and the distance remaining to values. If values are set during the journey, the destination will be displayed in the same the new values will be displayed after a way. delay of about 10 seconds. After the distance to destination has decreased to zero, the DIST will function as a trip meter (see ”Using DIST as a trip meter”). The starting value for the trip meter will be the last distance set in the DIST function. Example: The DIST setting was 100 miles. Once 100 miles (160 km) has been cov- ered, the DIST will start to function as a trip meter, the initial reading of which will be 100 miles (160 km).

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders