owners manual Skoda Superb

owners manual Skoda Superb - year of production: 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 - Skoda Superb II 2 owners manual EN

Document: pdf (17.92 MB) 267 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Skoda Superb, year of production 2008 - 2015:

Reducing or increasing the curvature of the lumbar support First read and observe the introductory information and safety warn- ›Push the switch A in the region of one of the arrowsė» Fig. Ěė. ings on page ěĚ.  Raising or lowering the curvature of the lumbar support Best protection is achieved if the top edge of the head rest is at the same level as ›Push the switch A in the region of one of the arrowsĖ» Fig. Ěė. the upper part of your head. 0he adjusted driver's seat position can be set in the memory of the Setting height seat » page ěĝ or the remote control key » page ěĝ. ›Grasp the side of the head restraint with both hands and push it upwards as re- quired » Fig. Ěę - . Note 0o move the head restraint downwards, press and hold the safety but- › ton » Fig. Ěę -  with one hand and press the head restraint downwards with  If the setting procedure is interrupted, you will need to press the button again. the other hand. 0he front seats and head rests must be adjusted to match the body size at all times and the seat belt must always be fastened properly to provide the most ef- Headrests fective levels of protection to the passengers » page Ėěĝ, Correct seated posi- tion. Removing/installing ›Pull the head restraint up out of the seat backrest as far as the stop (for the rear head restraints fold the seat backrest forward). ›Press the locking button in direction of the arrow » Fig. Ěę -  and pull the head restraint out. ›0o re-insert the head restraint, push it far enough down into the seat backrest until the locking button clicks into place. Removing and installing rear middle head rest Applies to vehicles using the 0OP 0E0HER system. Fig. Ěę Headrests: adjust / remove ›Pull the head restraint out of the seat backrest as far as the stop. ›Press the locking button in the direction of arrow Ė » Fig. ĚĚ, simultaneously press the locking button into the opening ė using a flat screwdriver with a Fig. ĚĚ width of maximum Ě mm and pull out the head rest. Rear centre head rests in vehi- ›0o re-insert the head restraint, push it far enough down into the seat backrest cles with the 0OP 0E0HER sys- until the locking button clicks into place. tem 3ARNING ■ 0he head rests must be correctly adjusted to avoid risk of injury. ■ Never drive with the head restraints removed - risk of injury. ■ If the rear seats are occupied, the rear head rests must not be in the lower position.  Seats and useful equipmentěĜ

Download PDF

Click here to download a pdf file with an instruction manual for Skoda Superb
year of production from: 2008

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.