owners manual Seat Cordoba

all ratings: 0 average rating: 5

COR_ING_0707 Seite 64 Mittwoch, 1. August 2007 6:25 18 64 Cockpit Coolant temperature too high Main beam headlights  First look at the coolant temperature gauge. The coolant temperature is too This warning lamp lights up when the main beams are on. high if the needle is over the warning area on the dial. Stop the vehicle, switch off the engine and wait for it to cool down. Check the coolant level. The warning lamp  lights up when the main beams are on or when the If the coolant level is correct, the overheating may be caused by a malfunction headlight flasher is operated. of the radiator fan. Check the radiator fan fuse and have it replaced if neces-Further information ⇒ page 92. sary ⇒page205. If the warning lamp lights up again after driving on for a short distance, stop the vehicle and switch off the engine. Contact an Authorised Service Centre or a qualified workshop. Fuel level / reserve  Coolant level too low This symbol lights up to indicate that the fuel tank is down to First look at the coolant temperature gauge. If the needle is in the normal the reserve level. range, top up with coolant at the earliest opportunity ⇒. This lights when only 7 litres of fuel remain in the tank. Also, an audible WARNING warning is given. This serves as a reminder to fill up with fuel at the earliest opportunity ⇒page172. • If your vehicle is immobilised for any technical reasons, move it to a safe distance from traffic. Turn off the engine, turn on the hazard lights and place the warning triangle. Anti-lock brake system (ABS)  • Never open the bonnet if you can see or hear steam or coolant escaping from the engine compartment. Risk of scalding. Wait until you can no A warning lamp system monitors the ABS. longer see or hear escaping steam or coolant. • The engine compartment of any motor vehicle is a dangerous area! The warning lamp  should light up for a few seconds when the ignition is Before carrying out any work in the engine compartment, switch off the switched on. It goes out again after the system has run through an automatic engine and allow it to cool down. Always note the corresponding warnings. test sequence. ⇒page175 There is a fault in the ABS if: • The warning lamp  does not light up when the ignition is switched on. • The warning lamp does not go out again after a few seconds. • The warning lamp lights up when the vehicle is moving.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders