or
owners manual Volvo 262
owners manual Volvo 262 - year of production: 1974, 1975, 1976, 1977, 1978, 1979, 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993 - Volvo 262 264 265 owners manual EN
Document:
pdf (4.31 MB) 104 pages
all ratings: 0
average rating: 5
text version of content this owner's manual page
from owners manual to the vehicle Volvo 262, year of production 1974 - 1993:
1977 Volvo 262 264 265
percent anti-freeze/summer coolant and 50 percent water all the year round. Top up to the "Max" mark.
If the engine is warm, and you are going to top up coolant, unscrew the cap slowly in order to allow any
excess pressure to escape.
NOTE: Do not top up with water only. Water by itself reduces the rust-protective and anti-freeze
qualities of the coolant. It can also cause damage to the cooling system if it should freeze.
NOTE: In warm climates where there is little risk of frost, water can be used without anti-freeze.
We recommend, however, to add a rust inhibitor.
pg. 60 Alternator, Replacing bulbs
Note: This car is equipped with an alternator.
When changing the battery or when carrying out work involving the electrical system, the following
should be observed:
1 A battery connection to the wrong terminal will damage the diodes. Before connections are made,
check the polarity of the battery with a voltmeter.
2 If booster batteries are used for starting, they must be properly connected to prevent the diodes from
being damaged.
The ground lead from the booster battery must be connected to the ground terminal of the car battery
and the positive lead from the booster battery to the positive terminal.
3 If a fast charger is used for charging the battery, the battery leads should be disconnected.
4 Never disconnect the battery circuit (for example, to change the battery) while the engine is running,
as this will immediately ruin the alternator.
Always make sure that all the battery connections are properly tightened.
5 If any electrical welding work is made on the vehicle, the ground lead and all the connecting cables of
the alternator must be disconnected and the welder wires placed as near the welding point as possible.
Replacing bulbs
The replacement of bulbs in the various lighting units is shown on the following pages. Make sure when
installing bulbs, that the guide pin on the socket fits into its corresponding recess.
When installing bulbs, do not touch the glass with your fingers. The reason for this is that grease, oil or
any other impurities can be carbonized onto the bulb and damage the reflector.
Replacing bulbs for instrument lighting and heater control lighting
Due to the location of the bulbs, their replacement should be carried out by a Volvo dealer.
Replacing bulbs for side marker lights
Remove the two Phillips screws which hold the lens. The bulb can now be removed by pressing it
inwards and turning it slightly counterclockwise.
file:///K|/ownersdocs/1977/1977_262_264_265/77262264265_03b.htm (6 of 14)12/22/2006 10:08:31 PM
Download PDF
Click here to download a pdf file with an instruction manual for Volvo 262
year of production from: 1974
Do you prefer pdf format?
Find out how to download
Enter the code to download PDF file:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
Volvo 262 264 265 owners manual
pages 63 - 69
Volvo 262 264 265 owners manual
page 66 / 104
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDF
Others owner's manuals for this model: