owners manual Nissan Murano

all ratings: 0 average rating: 5

Malfunction indicator lamp on steady — An The light will blink on for a few seconds after the emission control system and/or CVT mal-CAUTION VDCsystem stops limiting wheel spin. function has been detected. Turn the ignition The slip indicator light also comes on when you key to OFF and check the fuel filler cap. If theContinued vehicle operation withoutturn the ignition key to ON. The light will turn off fuel filler cap is loose or missing, tighten orhaving the emission control systemafter about 2 seconds if the system is opera- install the cap and continue to drive thechecked and repaired as necessarytional. If the light does not come on or go off, vehicle. Thelampshouldturnoff after acould lead to poor driveability, reducedhavethetractioncontrolsystemcheckedbyyour few driving trips. If thelamp does notfuel economy, and possible damage toNISSAN dealer. turn off after a few driving trips, have thethe emission control system. vehicle inspected by a NISSAN dealer. You Turn signal/hazard indicator donotneedtohaveyourvehicletowedtothe lights dealer. Security indicator lightThe light flashes when the turn signal switch
Malfunction indicator lamp blinking — AnThis light blinks whenever the ignition switch is inlever or hazard switch is turned on. engine misfire has been detected which maythe LOCK, OFF or ACC position. This functionVehicle dynamic control (VDC) damage the emission control system. To re-indicates the security systems equipped on theoff indicator light (if so duce or avoid emission control system dam-vehicle are operational. age: equipped) a) Do not drive at speeds above 45 MPHFor additional information, see “Security sys-After turning the ignition key to the ON position, (72 km/h). tems” later in this section.the light will illuminate. The light will turn off in b) Avoid hard acceleration or deceleration.Slip indicator light (if soabout 2 seconds if the vehicle dynamic control c) Avoid steep uphill grades.equipped) (VDC) system is operational. d) If possible, reduce the amount of cargoThis indicator will blink when the VDC system orThe light comes on when the vehicle dynamic being hauled or towed.the traction control system is operating, thuscontrol (VDC) off switch is pushed to OFF. This The malfunction indicator lamp may stopalerting the driver to the fact that the roadindicates the vehicle dynamic control system blinking and come on steady.surface is slippery and the vehicle is nearing itsand traction control system are not operating. traction limits. When the vehicle dynamic control off indicator Have the vehicle inspected by a NISSAN light and slip indicator light come on with the dealer. You do not need to have your vehicleYoumayfeelorhearthesystemworking,butthisvehicle dynamic control system turned on, this towed to the dealer. is normal. light alerts the driver to the fact that the vehicle 2-14 Instruments and controls
03.1.28/Z50-D/V5.0 

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders