owners manual Skoda Octavia

all ratings: 0 average rating: 5

s43s.1.book Page 63 Thursday, May 13, 2010 1:21 PM Lights and Visibility63 Note Service position for changing wiper blades The function of the automatic rear window wiper is only valid for Combi vehicles which – Close the bonnet. are equipped with the information display*. The function is activated in the factory.– Switch the ignition on and then again off. 4 – Then press the windscreen wiper lever in the position page61, fig.50 within A Headlight cleaning system* 20 seconds - the wiper arms move into the service position. The headlights are being cleaned after the windscreen has been sprayed for the first Taking off the wiper blade time and fifth time, the low beam or main beam are switched on and the windscreen – Fold windscreen wiper arm out from the windscreen and position the wiper blade 5 wiper lever was held in the position A page61, fig.50 for about 1 second.at right angles to the wiper arm . The headlight washer nozzles are moved forward out of the bumper by the water pres-– Take off the wiper blade in direction of arrow  fig. 51 . sure for cleaning the headlights. You should remove stubborn dirt (such as insect residues) from the headlight lenses at Attaching a wiper blade regular intervals, for example when refuelling . Please refer to the following guidelines – Push the new wiper blade over the wiper arm and turn the wiper blade into the page188, “The headlight lenses”. vertical position. You should remove any snow from the fixtures of the washer nozzles and clear ice in – Check whether the wiper blade is correctly attached. winter with a de-icing spray in order to ensure proper operation of the cleaning system. – Fold the windscreen wiper arms onto the window and switch on the ignition. By pressing the window wiper lever into the sprung position 4  fig. 51 or when A Replacing wiper blades for the windscreen wipers driving at a speed greater than 4 km/h, the windscreen wiper arms move back into the rest position. Wiper blades in proper condition are essential to obtain good visibility. Wiper blades should not be allowed to become dirtied by dust, insect remains and preserving wax. Juddering or smearing of the wiper blades could then be due to wax residues left on the windscreen by vehicle washing in automatic vehicle wash systems. It is therefore important to degrease the lips of the wiper blades after every pass through an auto- matic vehicle wash system. Fig. 51 Wiper blade for the windscreen wiper WARNING  The ignition must not be switched on if the front windscreen wiper arms are One cannot fold out the wiper arms in the rest position from the windscreen. Before folded out. The wiper blades would move back into their rest position and while replacing the wiper arms you must put them into the service position.doing so damage the paintwork of the bonnet.  If the windscreen wipers are handled ca relessly, there is a risk of damage to the windscreen. Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders